Re: Renard PX1 Pixel Controller is now available (current 2-8-15) Will you be getting anymore kits together or is it just the boards from now on??
P. Short wrote:If I'm looking at the correct schematic, this change does not need any modifications to the board itself (i.e. no cut traces and no jum...
Matt_Edwards wrote:Most of mine are packed away or in sealed boxes. I only have the original dc SSRs. I will see what I can do in a couple days. S...
P. Short wrote:That board could be easily assembled to use a shunt regulator instead of a series regulator because the pcb design has two series regul...
David_AVD wrote:You can use one lower voltage power supply to run the controller and a different (36V) one to power the actual lights. Having re-rea...
Matt_Edwards wrote:Ok the occasion where I needed to run some dc SSRs at 36v, I cut the track between the input voltage terminal and the volt regulato...
David_AVD wrote:Some time ago I did a page on the ACL wiki that shows how to use different voltage lights than what the controller can often accept. ...
Thank guys, although none the wiser!! Not sure if I'll get it done this year as I need to get the normal Renard controllers up and running first, whi...
Matt_Edwards wrote:Are you intending to use these ones: I would suggest you investigate further with the designer as I suspect they won't work at 36 ...
Post about controllers - moved to a more appropriate area!!
P. Short wrote:Yes, for those DC SSRs that have an on-board regulator. It appears that you don't have to worry about this for the SSRs that you menti...
P. Short wrote:Some of the DC SSRs that are described here or in the wiki use DC regulators to drop the input DC voltage of the SSR down to a much low...
P. Short wrote:There are two considerations here that I can think of. First, the transistors on the SSRs must be rated for higher than 36V if you are...
