Activity
 
Notifications
Clear all
mschell
@mschell
Noble Member
Joined: Nov 2, 2008
Topics: 41 / Replies: 2130
Reply
RE: Networking E682's - Router vs Network Switch - Unicast vs. Multicast

There are several misconceptions that have been mentioned in this thread. The purpose of pointing these out is not to disagree with the poster, but t...

12 years ago
Reply
RE: A small favor to ask

If your capture is correct, on the first set - the Mouser part is 120 Ohms, the Jameco part is 120K or 120,000 Ohms - not equivalent! I would definit...

12 years ago
Reply
RE: ADJ Lights on E1.31 Bridge

algerdes wrote:Update: In case anyone else needs this information: E1.31 Bridge set to REN wiring and DMX protocol RJ45 to XLR 1&2 (Ground) XLR-1 ...

12 years ago
Forum
DMX
Reply
RE: Pixel Controller decision

I think you'll find there's no "one right answer" to your question. In the beginning, there were just a few choices, of which the SANdevices E68x was...

12 years ago
Reply
RE: Looking to purchase holdman/ bethleham star

Keith R wrote:I have one made from his plans, but it is six feet tall and is 3/4" plywood. It would cost a fortune to ship. I have one of these as ...

12 years ago
Forum
Reply
RE: Great deal on drone/quadcopter at Bang Good

Just ordered a Hubsan H107C from Amazon. It will be here Friday. Trying to just dip my foot in the water to see how it goes. The CX-20 looks like a...

12 years ago
Forum
Reply
RE: WTB 70ct and 35ct LED strings

I might have some of those. I need to check my stock to see what I have left...

12 years ago
Reply
RE: 9 inch LED Snowflakes

PM sent - I'll take up to 15 if there are any left.

12 years ago
Reply
RE: Coro Arch prototype with no loss of light!

James, If you are still interested in making some of these, I would be interested in getting 10-20 full arches. No rush, but I can see them in the pl...

12 years ago
Reply
RE: 10W RGB LED Driver Board PCB with BOM

I'll take 10. Shipping to 27292

12 years ago
Forum
Reply
RE: e682 with Vixen - Quick Start Guide

Looks like you're well on your way to get it right. The thing to remember is that there are two mappings - the first is from Vixen to sACN(E1.31) and...

12 years ago
Reply
RE: Really Odd Pixel Strand Behavior, help me isolate the problem!

By putting the resistor in line with the data line (not between the data line and ground), you are changing the impedance of the data line. If the re...

12 years ago
Reply
Reply
RE: Christmas light show 2' star 5 way metal pole stand 16 hook head with 4 guy wire atta

I have an interest in the the base and possibly the hook head. I'll send you a PM as well.

12 years ago
Reply
RE: ECG-P2 and xLights Trouble

A couple of thots. There's always two mappings that you have to get right. The first is the mapping of channels in xLights to Universe (in software...

12 years ago
Page 2 / 145
Share: