mojuave1
@mojuave1
Estimable Member
Joined: Jan 3, 2019
Topics: 24 / Replies: 58
Reply
RE: sharkbite 1" pex from depot translucent?

Bwinter wrote:Yes, they work very well. That’s what I use for my arches (1” Sharkbite PEX): nice. where did you get the spiral trees I have been...

7 years ago
Reply
RE: Removing Random from Victors sketch

LateraLiz wrote:Yes, it goes through the test sequence as you describe, and then moves on to play the random sequence. If that section (random) is rem...

7 years ago
Forum
Reply
RE: Removing Random from Victors sketch

ScareCrowe wrote:I commented out what *should* be the random code. I copied it from the original post and just commented out the random code section. ...

7 years ago
Forum
Reply
RE: Removing Random from Victors sketch

I don't know really anything about arduino programming and what needs to be left and what can be removed

7 years ago
Forum
Reply
RE: Removing Random from Victors sketch

LateraLiz wrote:why not just comment out the section for the random sequence? It doesn't work I commented out that , the time out , sequence watch d...

7 years ago
Forum
Topic
Forum
Replies: 10
Views: 5300
Reply
RE: 2 computers 1 profile

jeffu231 wrote:The key thing to making this happen is to identify the profile folder on the primary computer. If you are not using multiple profiles, ...

7 years ago
Reply
RE: 2 computers 1 profile

Kept saying profile was locked so ended up deleting all profiles and then I was able to load profile to controller laptop from main laptop

7 years ago
Reply
RE: 2 computers 1 profile

Oh ok I get it I will do that then copy whole file I just built the setup on both computers the exact same

7 years ago
Reply
RE: 2 computers 1 profile

jchuchla wrote:You need to take the entire profile folder and copy it back and forth. Vixen needs to be closed on both computers when you're copying ...

7 years ago
Topic
Replies: 7
Views: 2369
Reply
RE: Mega tree and Vixen

MikeKrebs wrote:if you started at bottom left you ended up at top right at the end of string 5. String 6 probably started at the top instead of the bo...

7 years ago
Forum
Reply
RE: Falcon f4 not doing test for 5v nodes

TomL8345 wrote:Have you connected your V- (gnd) together yet? You will see some odd behavior if you are having a V- issue. I thought I did but went...

7 years ago
Reply
RE: code for mega ethernet

Arduino: 1.8.10 (Windows 10), Board: "Arduino/Genuino Mega or Mega 2560, ATmega2560 (Mega 2560)" new:47:23: error: unable to find numeric literal ope...

7 years ago
Forum
Topic
Forum
Replies: 1
Views: 5766
Page 2 / 6