Mark_M
@mark-m
Trusted Member
Joined: Feb 18, 2024
Topics: 2 / Replies: 73
Reply
RE: LED Curtain for Garage

munu wrote: Duh about the daisy-chaining. I should have read the user manual for the smart differential board to the end. In my mind, each of the dais...

2 years ago
Reply
RE: Tiltup MegaTree Pole

That guy is on the xLights Facebook groups. Tilt poles work well. I've seen plenty of people use this design. A good tried and tested design! The key...

2 years ago
Forum
Reply
RE: F48 & Smart Receivers

In 3 images from this post it should give you a reasonable idea what banking and chaining of SRx's mean. Banking concepts from the F16v3 is the e...

2 years ago
Reply
RE: Hail Mary Question

Martin has mentioned, ESPixelStick firmware on an ESP32 microcontroller can give a Wi-Fi to DMX bridge. Or find a USB dongle Vixen can support.

2 years ago
Forum
DMX
Reply
RE: Hail Mary Question

I had weird glitching in Vixen 3 with my three Arduino Mega controllers. I found it was because the laptop running Vixen only had a single USB 'root h...

2 years ago
Forum
DMX
Reply
RE: LED Curtain for Garage

munu wrote: white F48 1.02? .................. They only say max is 1024 per port. Actually, it seems more complicated, as 3 ports (1 port per bank) n...

2 years ago
Reply
RE: LED Curtain for Garage

munu wrote: Well, I am getting two of Ray Wu's 1m x 5m seed/pebble matrixes with 50mm (~2") spacing. I am hoping this will give a good effect. I just ...

2 years ago
Reply
RE: LED Curtain for Garage

I personally think taking a standard spool and cable tying to a plastic mesh is more cost effective & easier to repair. This a curtain version from 2...

2 years ago
Reply
RE: Falcon F48 and Outline

munu wrote: So, you use the same one that I use. I am glad you mention pebbles. I did read through that post you linked before. So, no pebbles work wi...

2 years ago
Reply
RE: Falcon F48 and Outline

I use the white F48 (the first one) with first generation smart diff receiver boards. The SRx2 can work with the white F48 (set it to old generation s...

2 years ago
Reply
RE: Falcon F48 and Outline

Using a single F48 is well within specification. Older F48v3 can handle 16k pixels and the new F48v4/F48v5 support over 32k. My own own show is one F4...

2 years ago
Reply
RE: LED Curtain for Garage

A plastic mesh with bullet nodes I think is okay if you are willing to make a support frame for it. Tom BetGeorge's garage door matrix uses coro with ...

2 years ago
Reply
RE: Pebbles & Roof/Window Outlines

The seed pixels you have linked to are 'okay' for seasonal outdoor use. If you want ready made mounting; a few people have made 3D prints to fit under...

2 years ago
Reply
RE: Starting Controller - DIY or Ready-To-Run?

I'd argue building because you then know how to disassemble for troubleshooting. But I totally understand that some people in this hobby value their t...

2 years ago
Reply
RE: What's your solution for loose pixels in coroplast?

On one of my home-made coro props I cut the holes slightly too big. I use electrical tape wrapped around the pixel.

3 years ago
Page 4 / 5