I'll take one of the Ren24s.
I want it if the previos buyer falls thru.
ill take 12 boxes of pure white
Would you take $115 shipped for one?
I currently use 2 renardSS16 in my display. Are these boards similar? Or do they require the external ssr's?
Mactayl wrote:.09 volts is way to low make sure with power off on the board you don't have a short from U2 pin 5 to ground (pin4 of U2). set your mete...
ok working my way thru the troubleshooting wiki andchanged to firmware with the osc turned off , using the internal one. I Next step says HB and ZC s...
Mactayl wrote:Do you have a meter (DVM) to check continuity and verify electrical connections from one IC to the next including resistors, connector a...
Well I swapped out the H11aa1, and reflowed the solder joints on the 9 pin and both RJ45. Also examined the back of board for any solder bridges etc. ...
ctmal wrote:From your original post it sounds like any controller you put first works and the 2nd controller doesn't. If that's the case, I'd assume ...
I have to work tonight but Ill look into that in the morning
With the diagnostic fw, the channels lit in order, but didn't respond to vixen
Mactayl wrote:I'm not sure but I thought you had this problem once before and it ended up being a cold solder joint or one of the IC sockets. Last ye...
everything there checks out
