Jonpro03
@jonpro03
Estimable Member
Joined: Dec 28, 2011
Topics: 13 / Replies: 167
Reply
RE: Help with my circuit design.

You're probably right. The max ground pin current for the chip is rated at 960mA. I could only imagine how hot it would get though. After a good reth...

15 years ago
Forum
Reply
RE: Can Vixen run on a Linux / ARM platform?

Also in line for a raspberrypi

15 years ago
Reply
RE: Help with my circuit design.

Well thats fantastic! Theoretically, if Im using 42mA per string to get a decent amount of light output, I could forgo the transistors and drive the s...

15 years ago
Forum
Reply
RE: Help with my circuit design.

Thanks for clearing that up for me! I setup a 2n2222a transistor and had it run a 60bulb LED string that I have wired for 12V (series/parallel). I got...

15 years ago
Forum
Reply
RE: Help with my circuit design.

buckanear wrote:If you are using a Bipolar transistor as a switch your best performance is when you force a beta of around ten. In that way you take t...

15 years ago
Forum
Reply
RE: Help with my circuit design.

LightUp wrote:Ahhh.... the joys of designing! There are many ways to design a similar function and different people will have different solutions. You...

15 years ago
Forum
Reply
RE: Help with my circuit design.

Sounds good to me. I'll change R2 to 820ohm.

15 years ago
Forum
Reply
RE: Help with my circuit design.

You don't think I'll loose any on the run out to a relay board (about 35yards in my case)? There has to be some resistance inherent to that line. What...

15 years ago
Forum
Reply
RE: which led's?

If you are building your own led strings, feel free to use any LEDs you'd like that have relatively close mcd numbers. There are many different factor...

15 years ago
Forum
Reply
RE: Help with my circuit design.

LightUp wrote:That circuit will also work. Question: Why do you like to drive the base of Q2 so hard? Look at XMM2 when Rext is connected. It indicat...

15 years ago
Forum
Reply
RE: Help with my circuit design.

I think I'm happy with this.

15 years ago
Forum
Reply
RE: Help with my circuit design.

Now that you mention it, Darlingtons may be overkill. I honestly don't see any channel pulling over 400mA. Typical draw is 240mA. Max is 1A. Another ...

15 years ago
Forum
Reply
RE: Help with my circuit design.

Oops, 5V on the controller and 12 on the relay board. And R1 is 22k

15 years ago
Forum
Reply
RE: Help with my circuit design.

I've been thinking of driving my load with Darlington transistors. Can I get some opinions on this design? The 10ohm load resistor is there to max out...

15 years ago
Forum
Reply
RE: DCcontrol

Updated circuit, still working on board revisions. Also considering forgoing DCSSR's and driving channels with Darlingtons. If so, I'll add PNP tra...

15 years ago
Forum
Page 11 / 12