My head is spinning with information, hopefully somebody can help me sort it out.
I want to make some 2 color led wreaths. I think I am down to either using individual led's or some of the strip led's I see people talking about. What mcd rating should I use if I went individual led's? There is such a wide range and I don't know what an average light string led is rated at. I have a small house and am only about 25' from the street, so any light will be well seen. These would also be mounted inside an enclosed front porch, but it would still be nice if they were sealed against wx.
Misc. info: newbie! I have been stocking up on lights for the past few years and trying to figure out what I wanted to do. I have yet to build any controller, I wanted to get some light designs down first. I was going to use regular string lights around a circular form (read bent clothes hanger), but that wasn't turning out how I wanted it to. So, I decided to try something with through-hole led's or possibly the strips. I'm just not sure what intensity I should use. I don't want it to be too bright so it's uncomfortable to look at. But, I also don't want it to be too dim....
I would really like this to be the year I can start to do something for an outdoor light show 🙂
daytimer wrote:What mcd rating should I use if I went individual led's? There is such a wide range and I don't know what an average light string led is rated at. I have a small house and am only about 25' from the street, so any light will be well seen. These would also be mounted inside an enclosed front porch, but it would still be nice if they were sealed against wx.
I'm not sure how helpful this is, but mcd by itself may not be a good indicator, since some manufacturers seem to misstate the numbers or measure them using different techniques. If there are a few types that you are considering, you might want to get a small sample and try them before getting too many. Even at that, sometimes they can vary from one batch to another.
Another consideration is ambient lighting. A dimmer LED might look fine if it is dark all around it, or even a bright LED might be too dim if it is near some other lights.
If you have some specific types you are considering, you could post a link and someone here at DIYC may have experience with those or be able to point out additional details to be aware of. Or, maybe choose LEDs from the BOM of another project that has successfully used them, if there is a project similar to what you are trying to do.
BTW, welcome to DIYC!
don
If you are building your own led strings, feel free to use any LEDs you'd like that have relatively close mcd numbers. There are many different factors that will change how 'bright' your wreath will appear, such as color of LED, how close the LEDs are to each other, what angle they're aimed or viewed at. The _best_ way to do it (IMO) is to build it first, adjust the brightness second. The brightness can be adjusted easily by changing the amount of resistance. I like to shoot for about 10mA for night time displays and adjust from there.
For example: 3 red LEDs in series on a 12V source and I want to set them at 10mA. Each LED has a forward voltage of 1.8V.
1.8 * 3 = 5.4V voltage dropped by LEDs
12 - 5.4 = 6.6V left to drop.
V=I*R => V/I=R
6.6V / .01A = 660ohm
Why is it we seem to forget the simple things like adjusting brightness by dropping voltage :munch: I know there is a lower limit, but some voltage drop would lower the intensity.
I didn't have any specific ones in mind yet. I have looked at Mouser, Digikey, superbrightleds, and valuehobby (an r/c hobby site I order heli stuff from). Anything from through-hole, to smd and the strips you can cut every 3 lights. I guess it will just be trial and error for a while.
So much to figure out, less than a year to figure it :hmm:
