Not familiar with that. Ill check it out. Thanks
I tried one of those too. It wasn't bad but range seemed pretty low though I didn't try it with the Dipole. My original TX was a hacked 12v car thin...
Sent ya a message
WakeFan wrote: I've switched to pixels and have the following... 12 REN8- 30.00 ea with enclosures and female ends 2 Ren16- 40.00 ea 1 Ren 32LV - 15....
Hi, interested in ren8 and 16. Which version of the 16 are they?
I thought country of origin was a requirement but it appears via quick search that that was required for food items but even that has been dropped. :...
Agree but where are these made? I can't find the country of origin. Seems like they are hiding that info ha ha.
I like it. Downloaded the STLs. Decent size too per the readme file. I know what my next prints will be. I know at night that the plastic colors ...
Board in place and printed mount
First print is done. Had to learn to use the slicer to make the gcode file used for printing. Made a mistake and didn't have the hot plate turned o...
Slight delay. Bad storm passed by in mississippi. May be a few days before I have power again. Will update print when I can print again lol
Not sure if this is of interest to anyone but here goes. Update: Got the printer finished last night. Took my time and made sure alignment was as...
I've bought from Paul Zhang via Amazon (Paul XZhang Direct-US) and direct from Blinky Pixels. Blinky is cheaper and honestly I couldn't tell the two...
