Ike
Ike
@ike
Eminent Member
Joined: Sep 30, 2011
Topics: 2 / Replies: 21
Reply
RE: New Hardware Developer - Putting lights on your homenetwork!

n1ist wrote:I know that the PCB was for an older proto, but a few suggestions: - Don't run any traces under the optos; the spacing is needed to keep ...

15 years ago
Reply
RE: New Hardware Developer - Putting lights on your homenetwork!

Materdaddy wrote:I think you have a misinterpretation of arduino. It uses avr-gcc to compile to "assembly" (a hex file) which is written to the ardui...

15 years ago
Reply
RE: New Hardware Developer - Putting lights on your homenetwork!

djulien wrote:Sounds interesting! Which PIC would you use for that? don My current prototype uses a PIC 18F26K22 running at 64MHz. For the etherne...

15 years ago
Reply
RE: New Hardware Developer - Putting lights on your homenetwork!

n8huntsman wrote:Sounds similar to Arduino? I started reading a book on the PIC and assembly but it was taking me about a full day to comprehend each...

15 years ago
Reply
RE: New Hardware Developer - Putting lights on your homenetwork!

n1ist wrote:Welcome; you will fit in fine. As Dirk mentioned, look into E1.31 to avoid reinventing the wheel, though maybe you have found a rounder w...

15 years ago
Reply
RE: New Dev Q - SOIC ok?

There are actually some really easy ways to do SMD soldering that doesn't require much of a steady hand. 1) Put down some flux on two opposite corne...

15 years ago
Forum
Topic
Forum
Replies: 10
Views: 4378
Topic
Page 2 / 2