You ship to Canada?
It says they're out of stock. Any idea when they will be back in stock?
The capacitor seems to have worked. At first it Did not work until I remembered I had disabled the unused channels in vixen I realized when it worked ...
Barnabybear wrote:Hi, those SSR’s are zero cross switching only. They will only switch on as the mains voltage crosses the zero point if the sketch ha...
Only 16 Channels by the way.
kev wrote:the Fotek SSRs may need 12v to trigger. Are you using 5v ?? The Fotek SSRs are rated 3-32V and I purchased them a few years back for anot...
Nevermind! If anyone doesn't want to use the FT232 for zparticle's code. Just tie Pin 0 to Pin 18 and Pin 1 to Pin 19 essentially tie your TX/RX 0 and...
UPDATE: My previous post was proven. I just tied pin 1 to pin 19 and pin 0 to pin 18 on my MEGA and that seemed to satisfy me.
Do I need the FT232R for this? Why can't I just use the built in FTDI chip?
Ok so my issue must involve the FT232 which I don't see the need for... How do I get around this?
Nope, all the values are right. I checked for any other headers but all I could find was STRT and END. I will attach the code as the entire sketch is...
