Drive around and see if any stores still have any Christmas items left. They are likely to be 75% off.
Komby RF1 receivers with a Arduino Uno sandwich is a diy pixel controller with the added benefit of being wireless. It is a very inexpensive way to g...
214 this morning! Well out of a list of 11 budude and I have 5 in common. And they were grouped together and in order in a group of 3 and 2. Hmmmmmmm...
2 more likes just came in, hope to hit 200 by morning! (1 from Wyoming, 1 from South Carolina)
First, Welcome Simon! I really hope you are right that lots of people are just getting into the holiday decorating spirit. (Unfortunately I do not thi...
Yes, you assume right. As long as your power supply matches the voltage of the wall warts you can use it to supply multiple strings. Also, the reaso...
I swore I would not buy anything this year but I just picked up 36 sets of 100ct GE multi mini LEDs today for 75% off. Currently 1/2 my multi colors a...
Your description sounds like those old lights they used to light up the old silver trees. 1 light with a rotating color wheel in front of it. Howeve...
I attach my controllers to a stake in the ground then put a black trash can over them.
Unfortunately I think it is getting more confusing to get into this hobby because they keep releasing new Renard boards but the old ones are still ava...
If you are new to the site, and new to Blinky/Flashy lights, and are reading the Wiki and thinking the Grinch is a good board for you as a beginner, ...
The 80% rule applies to continuous power, and continuous power is defined as 3 hours. So if you are blinking your Christmas lights you are fine at 100...
The Ren24 firmware has a default baud rate of 57600. Try slowing it down and see if that makes the ren24 work.
Unlike the Xbee equipment, you set the starting address on the Komby device so all is your Renards can use the same firmware.
