Notifications
Clear all
happymaurice
@happymaurice
Active Member
Joined: Feb 21, 2014
Topics: 1 / Replies: 8
Reply
RE: DMX WS2812 firmware

Hi, I would be glad to do it, only is that I may have to learn ASM programing from scratch,,,, when I read RPM's code for Address-setting part, I sear...

12 years ago
Forum
DMX
Reply
RE: DMX WS2812 firmware

Hi, thanks for your reply. I think I understand your "switchless" address-setting method, and the way to fulfill it. But, if I want to set start addre...

12 years ago
Forum
DMX
Reply
RE: DMX WS2812 firmware

Hi,the code for Address-set part seem to be interesting, might some "problem".. below is copy from your asm file added some of my comments (in bracket...

12 years ago
Forum
DMX
Reply
RE: DMX WS2812 firmware

Hello, how to set the DMX start address? It seems there is only a jumper.....

12 years ago
Forum
DMX
Reply
RE: Digital-Enlightenment open source USB dmx schematic issue

to who interested in this thread: I bought USBN9604-28m from a different supplier (Geographically located hundreds of miles from the former supplier),...

12 years ago
Forum
DMX
Reply
RE: Digital-Enlightenment open source USB dmx schematic issue

oh, ram can run this way, sounds good. i am sure the 3v3 pin not shortened to GND. I did not drive anything else eiteher, will remove the 1.5k and see...

12 years ago
Forum
DMX
Reply
RE: Digital-Enlightenment open source USB dmx schematic issue

thanks for your reply. i also guess the ram connection may not be the main issue. and I am not digging into the asm code to find how it make the addr...

12 years ago
Forum
DMX
Topic
Forum
DMX
Replies: 5
Views: 3132
Reply
RE: Enttec USB Pro protocol

I built a converter using my dev board and I am sure that I completely comply with this protocol, but I still can not get connected with free styler....

13 years ago
Forum
DMX
Share: