Activity
 
Notifications
Clear all
grages
grages
@grages
Reputable Member
Joined: May 29, 2007
Topics: 10 / Replies: 249
Reply
RE: DMX to Grinch converter Coop

RPM wrote:RJ, Are you still doing Co-op's for this board? Also, would it be possible to get the PIC code from you? I think RJ has stepped away from...

19 years ago
Forum
Reply
RE: Lynx Current COOP Status

RJ wrote:Because of the no edit thing it's hard to do a current list of paid. So here's where we are at: RJ There is a pole to change the edit opt...

19 years ago
Forum
Reply
RE: Post editing

I have been on the other side of the coin before also where someone quoted me and edited the quote to make me look bad. Fortunately the forum was set...

19 years ago
Reply
RE: Would anyone be interested

I think this site is what he is looking at. Link

19 years ago
Forum
Reply
RE: WANTED: Assembled/Programmed Renard 24 Controller

Oh Yea, get a decent soldering iron , look in the recommended tools and equipment section.

19 years ago
Reply
RE: WANTED: Assembled/Programmed Renard 24 Controller

Soldering really is not that hard and I had never done it right until I started this hobby. I put it off for a while, then I found this video How_To...

19 years ago
Reply
RE: USB Grinch Interface

fkostyun wrote:I think at this point, there is already the RenC and the DMX-Grinch - so - its kinda of a non-issue, as both can use a USB-Serial inter...

19 years ago
Forum
Reply
RE: DMX to Grinch converter Coop

RJ wrote:Who said I would post any code for it? LOL just messing with ya. I am working on cleaning it up right now I will have a bug in the programmi...

19 years ago
Forum
Reply
RE: DMX to Grinch converter Coop

RJ, Didn't I see where you had posted the Hex code for the PIC chip? Shawn

19 years ago
Forum
Reply
RE: Trailer connectors

This isn't any cheaper but has longer cables. Make sure to get a male and a female. 🙂 Link

19 years ago
Reply
RE: Lynx Current COOP Status

Well I have my Lynx in hand, it took 2 days to travel 100 miles. All of these parts are sure purdy! 🙂

19 years ago
Forum
Reply
RE: Ramsey FM distance?

wjohn wrote:200 mW TX, wire dipole, 52 ohm coax, >2000 feet Range is limited to ~2000 ft due to Line of Site and commerical TX operating on a close...

19 years ago
Forum
Reply
RE: USB Grinch Interface

Does anyone know if he is registered here... Maybe pteller

19 years ago
Forum
Reply
RE: New DMX dongle

RJ wrote:Posted @ 3:28 am Man Phil, Do you ever sleep? LOL Exactly but these are small parts also ssop 28 etc so I think we should go with the lit...

19 years ago
Forum
DMX
Reply
RE: Lynx Current COOP Status

😀 Yep, good chance!

19 years ago
Forum
Page 3 / 18
Share: