Activity
 
Notifications
Clear all
Franchise
@franchise
Estimable Member
Joined: Sep 8, 2007
Topics: 24 / Replies: 67
Reply
RE: E682 and net lights from Ray Wu

critic2 wrote:Depending on what version firmware you have installed on your 682, you can try to change the “pixel timing” setting. Try 300ms and see i...

4 years ago
Topic
Replies: 7
Views: 1511
Topic
Replies: 1
Views: 991
Reply
RE: Projector mapping and communicating with FPP

I used Heavy M to create the videos, saved them in mp4 format and then use FPP to play it.

5 years ago
Forum
Topic
8 years ago
Replies: 7
Views: 17448
Reply
RE: Enttec Open DMX Dongle Replacement

Hmm, I have seen people do that but I don't know how to do it. I will research it.

8 years ago
Forum
DMX
Reply
RE: Enttec Open DMX Dongle Replacement

Thanks for all the responses. The way everything is set up going wireless or using the Pixel controller won't work. Thanks for the suggestions though....

9 years ago
Forum
DMX
Reply
RE: Enttec Open DMX Dongle Replacement

I'll just notice that the lights will flicker off for a millisecond when they were supposed to be on. I'm using an old, slow laptop. When I bought th...

9 years ago
Forum
DMX
Reply
RE: Enttec Open DMX Dongle Replacement

Thanks for the responses. Will the actidongle offload my old laptop? Does it do more than the open DMX?

9 years ago
Forum
DMX
Topic
Forum
DMX
Replies: 11
Views: 21415
Reply
RE: DMX Cat5 cables not working

I think this is what I used for a cable. Since it doesn't work at all now, I don't think it is a sequencing issue. It is wet here in Florida with ...

11 years ago
Forum
DMX
Reply
RE: DMX Cat5 cables not working

Thanks for the replies. I'm learning a lot. The description of the cable I ordered says "4-pair of unshielded twisted copper strands". I would gladl...

11 years ago
Forum
DMX
Reply
RE: DMX Cat5 cables not working

Xlr. One is the standard and the other is the outdoor Xlr from Ray wu for his flood light. Sent from my SM-T800 using Tapatalk

11 years ago
Forum
DMX
Reply
RE: DMX Cat5 cables not working

Thanks for the info. I used dmx pigtails, so I didn't do the soldering between the wires and the pins. I did wire to wire and didn't do a good job. Bu...

11 years ago
Forum
DMX
Reply
RE: DMX Cat5 cables not working

Thanks for the reply. It was working for one day, so I don't think it is a configuration issue. For this part of my lights, I am using the open-dmx do...

11 years ago
Forum
DMX
Page 3 / 7
Share: