Well, After suspectng something in the Launcher I found the problem. Turns out I had a channel number labeled improperly after years of changing chann...
Ok, It still doesn't work. I tried the kill.bat file and it does shut down the tinyRDS software. One thing I will also note. When I run different .bat...
Aurbo99 wrote:change the RDS.txt to rds.txt I will try this, Is it tx sensative? did you set a single channel in the Launcher.dll setup? Yes this...
Well, I was unable to get it to work. If I run my .bat files they do go into the tinyRDS software. I can't seem to get vixen to launch anything. Here ...
I did have the Dynamic PS, RadioText set to rds.txt and Send on Change all set as you specified. I will try everything in the morning when I get home ...
Also, Don't use cross-fade between sequences. Keep it at zero
I would check your solder joints.
Seems easy enough and makes sense when it is explained that way. I have most of the work done, now I just have to adjust it. So it is my understanding...
I believe I have a couple at 50ms. the rest are at 100ms. When I was testing I had a 50ms open. If I ran a sequence one zone flickered. If I placed al...
I was able to fix some of my issues by replacing the cat-5 cables going to the controllers with better quality ones. I was getting misfires and tried ...
I have A MRDS192 and the PS command works fine. Now to try and get it set up with a sequence.
I wonder if this is EMI related flashing? Are you using LED'S?
I think the chips where part of the problem. Thanks again. EMI issue solved with Philips Surge Protectors
Thanks for all the help. Now on to figureing out a EMI issue in another zone. Jerome
