I've been playing around with the fading and some other commands and here is what i've found it. Most, if not all of this information has already bee...
You may also try FastLED3.1 instead of 3.0. If you look through their GitHub there are two versions. I am using 3.0.
qubie wrote:Hi djred2000 1st off thank you for sharing your sketches, life would not be as much fun without people like yourself. Now my problem I am...
jwamsley07 wrote:Can this be modified to work with 16 relays or is there a limit of 8? Yes, it will. Just modify the NUM_RELAYS define and the relay...
I wrote another sketch for controlling relays using E1.31 or ArtNet via ethernet or WiFi. I am using a Mega 2560 R3 with the Sainsmart 8-channel relay...
LightUp wrote:This is what zparticle used, G3MC-202PL-DC5 (see post #127); And its Digikey stock; One other comment. I don't know if the Omron has ...
I was thinking about going the valve route. It looks like all the 120 volt pond pumps can only be speed controlled using VFDs and that is cost prohibi...
Would these SSR's work to replace on the Sainsmart SSR board for dimming? These can handle 16 amps each at 120 volts. They are non zero-cross.
pancracio wrote:My setup isn't different to the one you all use. It only differs in the communication with the show control software. The guy behind H...
pancracio wrote: I've been working for a month with youtube Home Imagineering channel . Now I'm part of the team behind those homemade shows, and we h...
jwamsley07 wrote:This worked great on the Mega. I finally got an ether shield in and set up last night. I ran 300 WS2811 pixels with Vixen 3. Grea...
dmcole wrote:Do you have a handle on how many pixels an UNO will handle? Or a Mega? Also, there will be much midnight oil being burned over the next ...
dmcole wrote:Jared: Nice work. You apparently developed this on an M2560; have you tried it on an UNO? Also: have you tried it under IDE 1.6.0? C...
You can use my sketch here. Just remove all the FastLED and GWTS controls and add control for the relay board.
