Just wondering if anyone is still including GWTS output in their displays? I was thinking of adding it in again this year.
I would recommend a Teensy 3.2 for large pixel setups. Using the FastLED library and the OctoWS2811 output you can get 8 pins of parallel output. It ...
I thought i'd post my completed pixel controller. I am using a Teensy 3.2 to drive WS2811 12V pixels. Pixel data is passed from the Teensy through a ...
I posted my sketches on GitHub here. My finalized controller is made up of a NodeMCU to receive E1.31 or ArtNet data over WiFi and then output it ove...
I switched to using the OCTOWS2811 library integration with FastLED and now everything works perfectly on the Teensy 3.2. I am receiving 12 universes ...
I would also try some simple debugging such as printing out the serial data that the Arduino receives from Vixen to the serial monitor in the Arduino ...
sporadic wrote:Load this on your NodeMCU and give it a shot - Make sure to wire GPIO2 as your output, as I generate the ws2811 pixel stream using an ...
JHinkle wrote:Djred: The other thing I noticed about UDP reception with the standard ESP SDK was the amount of delay from transmission until acquired...
JHinkle wrote:I'm not sure if this will help you, but this is what I found. Here's a post I made on the Espressif site: In short, what I found was ...
MikeKrebs wrote:The serial debug output has been a bottleneck on other arduino projects. Have you tried with no monitoring? I have. I tried with no ...
sporadic wrote:I'm leaning towards a power supply issue or something up with the module. You have a schematic of how the ESP-01 is hooked up? The No...
sporadic wrote:Yeah, no lag at all. Is your e1.31 source wireless as well? Sent from my XT1094 using Tapatalk My RasPi running FPP is connected via...
sporadic wrote:I'd say either the serial connection or Due is the bottleneck. I've pushed just over 4 universes at 25ms rates doing everything on the...
av_guru wrote:I found what it was. It was a section in the code that only assigned the first 150 pixels to the first data pin. I just had to change th...
If all the pixels flash red, green and blue when you first power on the Arduino then you know everything is wired properly and the data signal is pass...
