deanno
@deanno
Eminent Member
Joined: Dec 7, 2007
Topics: 10 / Replies: 14
Reply
RE: How to: Led strips with Arduino and TLC5940 for newbies

Set every thing up and i get some leds lit up from the start, before i run vixen. They stay lit even when i run a sequence as well. Can some one tell ...

9 years ago
Forum
Reply
RE: How to: Led strips with Arduino and TLC5940 for newbies

LightUp wrote:USB is a serial port. The sketch uses the same port as your USB port so you can't use the "Serial Monitor" under "Tools" in the Arduino ...

9 years ago
Forum
Reply
RE: How to: Led strips with Arduino and TLC5940 for newbies

This is a great write up, thank you very much. But i have just 1 question, can i use a USB with this, or does it have to be a serial port only.

9 years ago
Forum
Reply
RE: Home Brew Lighting System - Arduino Mega - SainSmart 16 Channel Relay Board

CatMan42 wrote:If you're talking about the SainSmart 8 channel SSR board, no. It's set up for AC lights only. Is there any way to use the Arduino Me...

11 years ago
Forum
Reply
11 years ago
Forum
Reply
RE: Arduino powered show!

Jay R. wrote:I have trolled around on here a lot and wanted to show what I have done so far with Vixen 3, some arduinos and some LED strips. Thank you...

11 years ago
Forum
Reply
RE: UNO or MEGA board

Ok thanks , i will get this, SainSmart UNO ATMEGA328P-PU ATMEGA8U2 Sainsmart 8 Channel 5V Solid State Relay Module Board Would i need anything else...

13 years ago
Forum
Topic
13 years ago
Forum
Replies: 3
Views: 2283
Topic
Forum
Replies: 6
Views: 3206
Reply
RE: Newbie from UK needing help please!!!

Started new thread with questions

13 years ago
Forum
Reply
RE: are these any good

No dimming and will use a board.. Thanks

18 years ago
Forum
Topic
Forum
Replies: 4
Views: 2637
Topic
Forum
Replies: 0
Views: 1351
Reply
RE: only 8 channels

Thanks, i have the songs didn't realise you had to marry them up.Deanno

18 years ago
Forum
Page 1 / 2