CMNY
@cmny
Eminent Member
Joined: Nov 1, 2018
Topics: 4 / Replies: 16
Reply
RE: Foam Board in place of Plywood for Rooftop Cutouts?

i thought the foam board would hold up better and paint better. Paint does stick too well to corro. I also figured corro would be too flimsy but I l...

4 years ago
Forum
Reply
RE: Foam Board in place of Plywood for Rooftop Cutouts?

MikeKrebs wrote:foam board similar to what you linked is widely used in diy halloween. most times covered in drylok or monster mud and then paint. I w...

4 years ago
Forum
Topic
Forum
Replies: 6
Views: 4099
Reply
RE: High Voltage RGB LED COB Using MOFSETS??

I must be losing my mind. I figured it out. I had all the COB's wired backwards (cathode/anode). All fixed and now working. I have to run a couple...

7 years ago
Forum
Reply
RE: High Voltage RGB LED COB Using MOFSETS??

Been a while since I posted on this project but I still cant seem to get this part working. I have ten 100w COB RGB LED's. I am using 3 Arduino Mega...

7 years ago
Forum
Topic
Forum
Replies: 3
Views: 6222
Reply
RE: Arduino + Vixen + Xbee + RGB LED

This was resolved by another member on the forum!!! SO HAPPY!!! See here:

8 years ago
Forum
Reply
RE: General Serials not saving

dirknerkle wrote:With USB, you might be falling into the trap of Windows Power Management which, by default is turned on.... for some stupid reason......

8 years ago
Reply
RE: General Serials not saving

No, the com port number is not changing for each device. (Once a device has been assigned a com port number by the PC, it always remains that number ...

8 years ago
Reply
RE: Arduino + Vixen + Xbee + RGB LED

Sorry, by "Squib" yes I meant hub. I have tried 2 different types of hubs. One has external power supply and the other does not. Here are the links...

8 years ago
Forum
Reply
RE: Arduino + Vixen + Xbee + RGB LED

I am not sure what could be going wrong then when I try. I just attempted it again and plugged in 4 Arduinos (Prior to opening Vixen). All four devi...

8 years ago
Forum
Reply
RE: Arduino + Vixen + Xbee + RGB LED

I am limited to 3 if I don't daisy chain. Unless I am doing something wrong, Vixen doesn't allow you assign more than 3 com ports. In other words, I...

8 years ago
Forum
Reply
RE: General Serials not saving

Sorry, I just realized that there were replies to this post. Yes I am using arduinos. I have tried making sure they are powered prior to opening Vix...

8 years ago
Topic
Replies: 12
Views: 3883
Reply
RE: Arduino + Vixen + Xbee + RGB LED

Yes, my show planning actually started with my annual backyard fireworks display. I do one every year and each year it has gotten bigger. The past 2...

8 years ago
Forum
Page 1 / 2