chris2879
@chris2879
Reputable Member
Joined: Jan 2, 2008
Topics: 56 / Replies: 82
Reply
RE: Plugs/Sockets - Keeping things watertight

I do not do anything special, plug them in to the controllers. The controllers are powered from GFCI outlets, which the electrical codes defines is a...

12 years ago
Reply
12 years ago
Forum
Reply
RE: Pixel vs Incandescent Turn on Speed

Just an update. I updated the dimming curve to limit the output to 50% for the Pixabulbs. This makes the delay much less noticeable. I also think i...

12 years ago
Reply
RE: HELP: Pickit3 Target Device ID (0x0) does not match

I have seen the programmers act funny like this sometimes. In most cases it is a bad connection. Depending on what you are using to program the chip...

12 years ago
Forum
Topic
Replies: 4
Views: 1644
Topic
Replies: 2
Views: 1355
Topic
12 years ago
Replies: 5
Views: 1998
Topic
Replies: 0
Views: 1018
Reply
RE: Color Handing for White Lights

I got it to work. I deleted the color properties of the elements not working. Then completely deleted the color set and recreating it, then reassign...

12 years ago
Reply
RE: Color Handing for White Lights

Jon, I just ran into this issue again, this time while sequencing and can't seem to get it resolved. I have iscle group, with Left, Right and garage...

12 years ago
Reply
RE: Color Handing for White Lights

OK... I went and did some work in the preview on non-related elements, and now my issue went away.

12 years ago
Topic
Replies: 4
Views: 1994
Reply
12 years ago
Forum
Reply
RE: Pixel controller ethernet speed

That is a very good point Jon. I will most likely refine this design after this years season is done. Maybe I can make the configurations web based ...

12 years ago
Reply
RE: Pixel controller ethernet speed

This is my first year using pixels, however I have had my show going since 2007 using custom hardware talking the Renard protocol using about 200 chan...

12 years ago
Page 3 / 10