HELP: Pickit3 Targe...
 
Notifications
Clear all

HELP: Pickit3 Target Device ID (0x0) does not match

11 Posts
5 Users
0 Reactions
28.1 K Views
Posts: 113
Topic starter
(@randyr505)
Estimable Member
Joined: 18 years ago
[#34333]

I have a pickit3 that I used to program my PX1 successfully. About a week later I finished my other 3 PX1's and tried to program them. I now get the following error:

Connecting to MPLAB PICkit 3...
Firmware Suite Version.....01.34.11
Firmware type..............Enhanced Midrange

Target detected
Target Device ID (0x0) does not match expected Device ID (0x2760).

I am using mplab_ide but have also tried mplab_ipe (v2.26). Both running on linux (ubuntu 14.04). It seems as if I can read the pic just fine but not sure how to verify that.

2014-11-30T12:02:51-0600- Reading...

The following memory area(s) will be read:
program memory: start address = 0x0, end address = 0x1fff
configuration memory
EEData memory
User Id Memory

Reading...
Read complete
2014-11-30T12:02:57-0600- Read complete


10 Replies
David_AVD
Posts: 991
(@david-avd)
Noble Member
Joined: 17 years ago

That error usually means the target chip is not powered. You need to either have the target board powered up power it from the programmer.


Reply
Posts: 113
Topic starter
(@randyr505)
Estimable Member
Joined: 18 years ago

I have tried both powering via my 12v supply and via the pickit3 by setting it to power the board. The LED's come on in both cases so I assume it is working. It complains if I power 5.0v so I have it set to either 4.75 or 4.6x depending on which program I use. The green and the yellow on the PX1 both come on.


Reply
Posts: 6728
(@p-short)
Illustrious Member
Joined: 19 years ago

I think there is a different error message for when the chip is not powered. I think that message means either that there is a connection problem between the programmer and the PIC, or that something is pulling the programming pins down. I don't think that the latter would be the case here, as the programming pins are used with LEDs that are pulled up. However, ensure that the pixel strings are not connected to the board, and then lower the programming voltage to a lower voltage, perhaps 3.6V or 4.0V. Alternative, see if the chip can be programmed when installed in an adapter socket, rather than on the board, and see if that helps.


Reply
Posts: 113
Topic starter
(@randyr505)
Estimable Member
Joined: 18 years ago

I tried lowering the voltage also but don't recall what happened. I will try that again. My adapter socket just came in a few days ago so I can try it but I don't have a clue how to use it. I have this one: PIC Programming Adapter. It didn't come with any instructions. That was my next thing to try. Thanks for your suggestions. I'll let you know how each go.


Reply
Page 1 / 3
Share: