joeengler wrote:Here is a complete Mouser BOM for import mlkren wrote:Here is the BOM through Mouser. FYI It looks like your crystal in both of t...
jstjohnz wrote:Great prices on the small parts. Combine this with Digi-Key for the terminal blocks and resistors everything's down to 2 vendors. I w...
ptone wrote:so board in hand, ready to order parts. I know this has been a fast moving project, so what is the current recommendation for BOM - the p...
Along the same question, what is the difference between different manufactures? Just looking at different datasheets from different manufactures they...
You can get it at Mouser too for less Tyco 59803-1
jstjohnz wrote:That looks interesting, and the price is right. Can't quite figure out how the female part works though, is it a punch-down? Might ha...
Doing some searching for parts I found these: Mouser 571-6404564 Mouser 571-3-640441-4 Only $3.90 total for 16 pairs instead of $20 and no need to cr...
What is the estimate on the other parts needed? How much of a savings will you get from a group buy? I'm not in a hurry to get one so I can wait for...
IdunBenhad wrote: A word of Caution: changing the triacs to one that has a higher current rating does not mean you can have "more lights" on the cir...
I'm not sure if these are the right ones but it looks like it to me. They are only 0.45 each and shipping is cheap. Would you have to change the g...
OK, thanks. It does look like Saelig has free shipping on orders over $250 so if there is a group buy then it will at least be extra shipping added f...
jstjohnz wrote:I think it's the 810 that has the metric pin spacing. AFAIK the only difference between the 811 and 812 is those 3 led outputs. Eithe...
Sounds Great! Thanks.
jstjohnz wrote:I think it's the 810 that has the metric pin spacing. AFAIK the only difference between the 811 and 812 is those 3 led outputs. Eithe...
Looking over your pictures I see that you switch from the WIZ811MJ to the WIZ812MJ. Will both modules be supported? It looks like the difference is ...
