Activity
 
Notifications
Clear all
carlk
carlk
@carlk
Eminent Member
Joined: Nov 21, 2009
Topics: 0 / Replies: 34
Reply
RE: Ear to Ear Networking.

7 1/2 hours is a great run. I like the hats idea too. Carl

14 years ago
Forum
Reply
RE: Ear to Ear Networking.

Hello lightman, I believe the default brownout voltage for the SX microcontrollers is 4.2 Volts. You could try setting this for 2.4 Volts and get get ...

14 years ago
Forum
Reply
RE: Recommended relay

Mouser has this 120V relay 528-976B-120A I'm assuming the ren puts out 5V to control the SSR, and that the switched control is low current (being 3V)...

14 years ago
Forum
Reply
RE: Pneumatic Air Cylinder Telescopic Mega Tree Pole

I think an o-ring may have too much drag. Before plastic seals, TV live truck masts used a leather seal lubricated with a light oil. There was an oile...

14 years ago
Forum
Reply
RE: DirkCheapSSR Group Buy Round 2 - Interest

I would buy 2 or 3 units with RJ-45s. Thanks, Carl

14 years ago
Forum
Reply
RE: Renard SS 2012 Round 2 Group Buy [CLOSED]

Re: Renard SS 2012 Round 2 Group Buy Hello James, I would like 64 of the BTA06-600CW Triacs 3 SS24 Heat Sinks 2 SS16 Heat Sinks Thanks, Carl

14 years ago
Forum
Reply
RE: I accidentally shocked my DMM, any ideas on fixing it?

The fade of the LCD looks like a slow voltage drop. You should probably get the pinouts of the three chips and check for the correct voltage(s) when t...

15 years ago
Reply
RE: Hacking cheap talking skulls? Would DCSSR work?

I think I would try and drive it with a DCSSR. By using low end values from vixen and varying the voltage to the SSR, you may find a range that will m...

15 years ago
Reply
RE: DIY Software

I would try sending 3 sync bytes - 7E (126) an ID byte - 80 (128) and 8 data bytes - FF (255) and see if it works. This should turn on the first 8 r...

15 years ago
Forum
Reply
15 years ago
Forum
Reply
RE: 2012 Renard SS Group Buy Round 1 {CLOSED}

Re: 2012 Renard SS Group Buy Round 1 {THREAD WILL UNLOCK ON THE 28TH} I would like 2 ss24 pcbs 2 ss24 bom 2 ss24 heat sink 16 extra triacs Thanks

15 years ago
Forum
Reply
RE: Please decorate wisely

I broke two fingers (and the ladder) three years ago falling off the ladder while putting lights in a tree. I haven't put any lights in the tree since...

15 years ago
Forum
Reply
RE: Magic Jack

Looks like the Magic Jack plus doesn't need the computer, just the internet connection. If you plug it and your router into a UPS you should be OK wit...

15 years ago
Forum
Reply
RE: Renard SS8 Pad Destroyed

I would replace the resistor, bending the leg over to the triac pad to make the connection. (sorry, I see that labrat has already suggested this) Carl

15 years ago
Forum
Reply
RE: Renard ss parts/PCBs/ heatsinks Group Buy

Received mine today also, I have already fired up the iron, and I'm about to solder on the triacs. Thanks, Carl

15 years ago
Forum
Page 2 / 3
Share: