My OpenRGB software can do what you want. It's mainly designed for RGB computer hardware (keyboards, mice, parts, etc) but it can output E1.31 to con...
Doesn't matter the controller really, just that the data out voltage is good. Whether it's an Alpha pix, Arduino, Pi, etc. the same signal is coming ...
Are you using pixels? How long are your data line runs? I had flickering lights on my roof yesterday after putting up strips around my front door. ...
You can use the Generic Serial protocol on Vixen plus your Arduino and whatever existing library you use to drive the GE lights. Personally, I modifi...
I would definitely share my changes. Right now I just hacked it in to make it work, but I could clean it up and add a Checksum option which would be ...
I just compiled the whole thing as I don't know what all is needed. Use the Release configuration and it should build just fine.
I would build it with 250000. Edit: Source is here:
I'd change it to something like this: if( serial_buffer[start] == 'A' ) { //unsigned short sum = 0; //for( int i = 0; i ...
I think that came from the same ws2812 library I'm using: It looks like it's using an ASM waiting loop to get perfect timing. Not too uncommon. I...
200 pixels at 1Mbps works fine (I only actually have 150 connected but it's sending and processing 200 RGB channels) and refresh rate is at least 30Hz...
Oh nice! I do have a 3D printer but the clear filament I have isn't very good. I might buy the faceted clear covers from aliexpress to match the one...
I ordered a set of these: At $45 per 50 lights they're pricy, but I wanted actual C9 style bulbs and they look great. I then proceeded to accident...
Oh wow, I just looked up the datasheets for ATMega328p and CH340G and it looks like both can handle even higher baud rates than 250k. I might be able...
