BRETT
@brett
Trusted Member
Joined: Feb 27, 2009
Topics: 9 / Replies: 23
Reply
RE: How do u stop the LED from Rusting

Yes it was tricky to feed a 10 m string into the tubing. All i did was lay the strings out flat in my yard. To make a 6m string hammer a ped into the ...

17 years ago
Forum
Reply
RE: How do u stop the LED from Rusting

Pictures of continuous shrink tubing, purchased from a Melboune company called Australia Wrapping Company, but i did find similar products in America ...

17 years ago
Forum
Reply
RE: How do u stop the LED from Rusting

I was also concerned with the rust factor in testing during the year. As this was my first year at blinky flashy and I had already invested lost of mo...

17 years ago
Forum
Reply
RE: How about Low Voltage AC then?

I have built and tested a xmus board to switch 12v, primaraly for driving LED,s that I purchased from Hong Kong. The leds come pre wired with resistor...

17 years ago
Forum
Reply
RE: Ren16 regulator problem

Sucess at last, blinky flashy on 1 channel, it,s a start. Was either firmware on pic or regulator. Thanks for everyones help

18 years ago
Forum
Reply
RE: Ren16 regulator problem

Got home from work, desoldered 5 reg, put new one in, re programmed with different firmware, tried programming two that got hot, no go, FRIED. So so f...

18 years ago
Forum
Reply
RE: Ren16 regulator problem

Realized input from one transformer was ac , swapped for another that output dc. So that got me 5v at test point but still really hot regulator and pi...

18 years ago
Forum
Reply
RE: Ren16 regulator problem

OK, from the start. I have built and tested 3 x ren24ss boards from wayne, same regulator , same 12v input. No problems there, they ran no worries. I ...

18 years ago
Forum
Reply
RE: Ren16 regulator problem

I am using the ren 16 ssr rev 1.9.1.

18 years ago
Forum
Reply
RE: Ren16 regulator problem

I'm building the ren 16ss, the hot chip I refer to is the 16f688 near the regulator. I am also bringing power in from a standalone tranformer aand con...

18 years ago
Forum
Topic
Forum
Replies: 14
Views: 4407
Reply
RE: REN ss24

Thanks for everyones help, I now have a ren 24ss blinking and flashing on all 24 channells, running in AUs at 240 volts. What a blast!!! Thanks Guys

18 years ago
Forum
Reply
RE: REN ss24

Pin 1 and 2 on moc3023 always read 5v, regardless of whether i use diagnostic chip or operational chip. 5v test reads 5v. zc test reads .2 volt. Dia...

18 years ago
Forum
Topic
18 years ago
Forum
Replies: 12
Views: 4762
Reply
RE: Cap values ren16

Thanks for the info link. Answered my question and also made me aware of another problem I didn't know about, the problem with the trace on h1. Could...

18 years ago
Forum
Page 2 / 3