dirknerkle wrote:Simple test for the data format: Use a USB Explorer with an xbee in it, connect to it with XCTU software, open the XCTU terminal scr...
budude wrote:But there are settings on the E1.31 bridge - at least for baud rate - I assume this is RPM's bridge you have? Brian, The E1.31 is one f...
LabRat wrote:I would agree that you have demonstrated that the PC (#2) is transmitting the data. So at this point we have to focus on the receivers. S...
Lab Rat, I have 2 computers. On #1 I have the programming board for the ren-w v6. I have an XBee plugged into that. Using the X-CTU software you can ...
I'll take 3. The money is on the way.
klyneshouse wrote:In MN they pay a lot more than what CA and TX do per foot of traffic markings.:roll: And have you ever seen/heard of the section ...
Put me in for: 1 x PCB 1 x BOM1 1 x BOM2 Thanks a lot.
Thanks for the 2.5 Chris. It seems to work fine and will be really handy. Thanks again for your work.
I would be interested in a version for Vixen 2.5. That's what I run all the time. Thanks for your work on this. I appreciated it.
I have one of these and actually, for $25, it's not too bad. I used mine to run a video of St. Jude children on a 14" screen at the donation station. ...
budude wrote:No, because in the end it's still a serial stream to the Renards with all the same restrictions - they don't speak E1.31 directly. Of cou...
Couldn't the E1.31 expand these channel restrictions? This year I ran over 300 channels using the J1SYS E1.31 adapter with no problems. Also, you get ...
That's an impressive line up. Thanks Dirk.
Are these half wave or full wave LED's?
