Activity
 
Notifications
Clear all
biffklg
@biffklg
Estimable Member
Joined: May 31, 2007
Topics: 34 / Replies: 137
Topic
Replies: 1
Views: 1146
Reply
RE: ALL of my 2008 sequences

intwoit2002 wrote:I really like your site. I must however be dumb. I can find the videos, but cannot locate the associated vixen file. Please let m...

17 years ago
Forum
Topic
Forum
Replies: 8
Views: 5187
Reply
RE: ren-c/olsen dimming problems

nope, I never did figure it out. I have just come to accept some of the dimming problems. Some nights are better than others for some reason...

18 years ago
Forum
Reply
RE: ren-c/olsen dimming problems

P. Short wrote:How is it that you have four olsens on two Ren-C's? I'm a bit confused by this...there should be one Olsen controller per Ren-C. My ...

18 years ago
Forum
Reply
RE: ren-c/olsen dimming problems

ErnieHorning wrote:Do you have the visualizer turned on during the show? If so, try disabling that plug-in. No I do not. I get these same dimming e...

18 years ago
Forum
Reply
RE: ren-c/olsen dimming problems

Do you have the visualizer turned on during the show? If so, try disabling that plug-in.quote] No I do not. I get these same dimming effects even if...

18 years ago
Forum
Topic
Forum
Replies: 16
Views: 4348
Reply
RE: Ren-C Overrun & Framing

I tried the suggestion of shortening the cable from the Ren-T to the Ren-C and it worked. My first box is approx 25 feet from the Ren-t's and never ha...

18 years ago
Forum
Topic
Forum
Replies: 2
Views: 1652
Reply
RE: Never been booted off a forum until now

It's been a few months since I have visited DIYC and might have missed some stuff, but, did KC sell his software to AL? I watched the video tutorials ...

18 years ago
Forum
Reply
RE: Lots of new updates!

wow, nice work. Once you get the ledtriks done you might want to test it on your computer, especially with two "screens". LedTriks is a BID computer h...

19 years ago
Forum
Reply
RE: REN-C inop

P. Short wrote:If the symptom is 'only the power LED comes on', then I could come up with another set of firmware that just flashes the other LEDs on ...

19 years ago
Forum
Reply
RE: REN-C inop

I just went and checked the 2 pins that had the .5V before when the meter was set at 10VDC and set the multi to .5VDC and probed them again. The worki...

19 years ago
Forum
Reply
RE: REN-C inop

RavingLunatic wrote:So it appears that the PIC isn't doing its job, and I believe that you have already swapped those around. So compare the inputs ...

19 years ago
Forum
Page 1 / 12
Share: