On the size it should be as many channels as you want on universe 1 up to 510, then add 510 on universe 2 start at 511 that will give you up to 1020 c...
A picture of your setup display in vixen might help also are you using one e682 or two
Each LED =3 pixel for instance in your pic it shows 3 LEDs thats 9 pixels, so if you count 100 LEDs = 300 pixels as far as how many pixel per connect...
1) Am not sure but it should work, I think its explained in the manual or on the wiki 2) 300 pixel so you mean 100 count. 3) when you go to vixen setu...
Have you tried to connect only the two LSDs without the other boards and if they work then try LSD LSD REN REN and so on. are the rgbs the same voltag...
you dint mention if you swap the cables or use the same, and check for proper voltage as well
There are many different boards out there I did my research and for me it was the SanDevice E682. I been using two renard 64xc for about two years an...
Yeah 3.0 to 3.1u1 I guess am a little behind but i will upgrade after christmas I dont want to mess anything up
I had my Arches disappear when I upgrade to 3.0 but when the last patch came out 3.1u1 that issue got fixed and everything runs good except the schedu...
may be this will help
Yes they are expensive but if they work with the E682, is worth it to wait for the sale after christmas 🙂
I'll look next time I'll go to the store
I wonder if these will work with SanDevice E682
Is pixel building day:wink2:
You are probably doing it right am assuming you are using vixen, I was adding some arches to my preview and for some odd reason they keep disappearin...
