Activity
 
Notifications
Clear all
AlfredNobel
@alfrednobel
Active Member
Joined: Jan 5, 2015
Topics: 1 / Replies: 15
Reply
RE: Site Upgrade or not?

I've been contemplating whether or not to post this but I feel like I need to. I think that part of what makes this site so valuable to both newcomer...

3 years ago
Reply
RE: looking for Pentatonix sequence

Here is a vixen 3 vpkg file for Pentatonix Mary Did You Know you can import. It has both a 16 channel renard based setup as well as a pixel based setu...

5 years ago
Forum
Reply
RE: ESPixelStick 4.0.0-beta1 Release

Is there some trick to getting it to save the settings when you configure it? I flashed an ESPixelStick v3 with the new firmware and it won't save the...

5 years ago
Reply
RE: FPP Sending Incorrect E1.31 Channel Data to ESPixelStick

You're right! In FPP output it should have read starting at 17, but I didn't type the 7 though my brain kept reading it as 17. I must have looked at ...

9 years ago
Reply
RE: FPP Sending Incorrect E1.31 Channel Data to ESPixelStick

Here are the ESPixelStick Device Settings: I feel certain that this is just some setting that I messed up when translating my Vixen output setting...

9 years ago
Reply
RE: FPP Sending Incorrect E1.31 Channel Data to ESPixelStick

Here are some screenshots of my output settings from vixen: Renard Outputs: ESPixelStick: FPP Output Pages:

9 years ago
Reply
RE: Share sequence files (also found a bug!)

The idea of a second sequence save format intended for sharing would be wonderful. I have a suggestion for a mechanism to import sequence+setup data ...

10 years ago
Reply
RE: VAST FMT Transmit Power

Don't forget, there is a 'send settings to device' and a 'save settings to eeprom' use both and make sure the device gets restarted in order to pickup...

11 years ago
Forum
Reply
RE: VAST all in one V-FMT212R FM Transmitter with RDS

In the software control system, you have to pick your frequency, and hit 'send config to device' and then 'save config to device'. Then you might nee...

11 years ago
Forum
Reply
RE: fox cub issues

I fried a 328p via feeding it too much voltage and when it fried pin 9 was dim, 10+11 were half on. I only knew it was dead for sure because I could...

11 years ago
Forum
Reply
RE: fox cub issues

Sounds like a fried 328p possibly. To test, upload the arduino blink sketch and monitor pin 13. If you can't upload at this point it is probably fried...

11 years ago
Forum
Reply
RE: fox cub issues

Having lights stay on sounds a bit like your atmel328p-pu is not programmed correctly. Have you verified your chip has the arduino boot loader and the...

11 years ago
Forum
Reply
RE: Original Carson Williams Wizards in Winter Sequence

In case anyone was looking for it; I've converted the Vixen 2 sequence found in this thread for Carson Williams - Wizards in Winter to a Vixen 3 seque...

12 years ago
Forum
Reply
RE: E1.31 Arduino GECE controller

Thanks Jon. I've looked through the Komby code and to be honest it's actually pretty difficult for me to separate what is sACN parsing and what is con...

12 years ago
Forum
Page 1 / 2
Share: