TIG welding, takes a lot more skill to learn and perform properly. For wireframes, the MIG welder is the way to go. Easy for beginners to use and learn.
deonb wrote:Ok, thanks. This helps a lot. How about TIG? At what point is TIG more appropriate than MIG or ARC?
We have both at the shop. I taught myself how to Tig and am fairly good at it. A TIG welder gives you a lot more control. If you know how to braze Tig welding is fairly easy to pick-up but is way overkill for most home applications. A big issue is you have to jig everything. You need both hands to Tig weld because you feed the wire from one hand while you use the other to create the puddle. With a MIG, the wire is in the wand so you can use the other to hold two pieces of metal where you want, pull the trigger and they stick. It also takes twice the money to get a good Tig welder. You use AC to weld aluminum and DC to weld steel/stainless.
The last TIG welder I priced for my personal use was $2300+ with all the needed consumables and accessories. So, that is a bit high for the casual user. And they all use 220V input. Some are 440V.
Eastwood company makes a pretty nice ac/dc Tig welder that welds steel, stainless and Aluminum runs on 110vac comes with foot pedal $699 on sale. For wire frames, a mig is probably the best bet Eastwood makes those too
Sent from my iPad using Tapatalk
ArcadeNut wrote:Eastwood company makes a pretty nice ac/dc Tig welder that welds steel, stainless and Aluminum runs on 110vac comes with foot pedal $699 on sale. For wire frames, a mig is probably the best bet Eastwood makes those tooSent from my iPad using Tapatalk
I have the Eastwood 135 Amp Mig Welder and I really like it. Runs on 120v which makes it very portable, unlike a 220v unit.
Unless you are making your frames out of stainless steel or aluminum a tig welder would be overkill. Powder painted aliminum frames would be very nice though.
Santa brought me one of these this year to use with the welder he brought me a couple years back (helps that Santa had a 25% off coupon):
http://www.harborfreight.com/adjustable-steel-welding-table-61369.html
Now I can stop scorching the top of my venerable B & D Workmate.
I'd like to improve my current "skeleton" construction for my megatree. I have 1/2" EMT (electrical metallic tubing) which I believe is galvanized mild steel. What type of welder would be needed to tack wire (1/8") onto this? I believe there's an issue with toxic fumes when welding anything galvanized - can this be avoided simply by welding with adequate ventilation (e.g. outside) or is it still a hazard?
Use a wire feed mig welder. In order to get a good weld, you will need to remove the galvanizing first. I use the blue flap disc on my grinder for this. Wear a mask. The amount of fumes from a "tack" is minimal, you can probably just weld without grinding since the galv on emt is very thin.
Sent from my iPhone using Tapatalk
ArcadeNut wrote:Use a wire feed mig welder. In order to get a good weld, you will need to remove the galvanizing first. I use the blue flap disc on my grinder for this. Wear a mask. The amount of fumes from a "tack" is minimal, you can probably just weld without grinding since the galv on emt is very thin.Sent from my iPhone using Tapatalk
Galvanized material IS BAD STUFF to weld on. It is very toxic!! Make sure you have good ventilation and certainly do not breathe ANY of the fumes if at all possible!!!
Sorry if I seem critical about this but it is just that bad.

