My first wireframes
 
Notifications
Clear all

My first wireframes

19 Posts
12 Users
0 Reactions
9,076 Views
flstc_93
Posts: 51
Topic starter
(@flstc-93)
Trusted Member
Joined: 16 years ago
[#18390]

These are my first attempt at making wireframes. No special tools, except a mig welder. All bends made with a vise, hammer and elbow grease. Santa is just under 5' tall and the star is 4'. made with 1/4 in steel rod. Pattern was made for santa by tracing an image with tracing paper, then scanned and enlarged to size. Enlargements were printed at Kinkos (wide format), then used my wifes sewing tape measure to measure pieces to cut. All said and done both pieces cost me about $20... I love this hobby,,, many thanks to this forum for the ideas and knowledge to do this !!!! DIYC Rocks !!!!

Beth Star
Santa Chimney 1

18 Replies
imbluenote
Posts: 1615
(@imbluenote)
Noble Member
Joined: 15 years ago

looks excllent. I am going to try to make a couple of wireframes this year...good inspiration!


Reply
ukewarrior
Posts: 4674
(@ukewarrior)
Illustrious Member
Joined: 18 years ago

Very nice.

I would like to suggest you upload and share your images !

flstc_93 wrote:These are my first attempt at making wireframes. No special tools, except a mig welder. All bends made with a vise, hammer and elbow grease. Santa is just under 5' tall and the star is 4'. made with 1/4 in steel rod. Pattern was made for santa by tracing an image with tracing paper, then scanned and enlarged to size. Enlargements were printed at Kinkos (wide format), then used my wifes sewing tape measure to measure pieces to cut. All said and done both pieces cost me about $20... I love this hobby,,, many thanks to this forum for the ideas and knowledge to do this !!!! DIYC Rocks !!!!


Reply
Posts: 187
(@stevemaris)
Estimable Member
Joined: 16 years ago
Reply
flstc_93
Posts: 51
Topic starter
(@flstc-93)
Trusted Member
Joined: 16 years ago

Good Point !!! Assuming you meant the patterns, I need to reduce the file sizes to upload,, but will do so shortly.... Here are a couple...


Reply
lightman
Posts: 1524
(@lightman)
Noble Member
Joined: 19 years ago

Nice job!


Reply
jem5136
Posts: 306
(@jem5136)
Reputable Member
Joined: 17 years ago

These look amazing!! I really want to start making my own wireframes, but I don't have the time or equipment to make any, not yet anyway. Maybe someday I'll get around to trying it out 😀


Reply
michaelc
Posts: 1540
(@michaelc)
Noble Member
Joined: 19 years ago

Those look amazing. Nice work, especially for your first time out. The curves on santa look great.

I just got a 90amp welder at christmas. I haven't even opened the box yet. I promised myself I wouldn't even look at it till all this years stuff is stowed away. I want to make a Heat Miser/Snow Miser snowball / lightning fight.


Reply
michaelc
Posts: 1540
(@michaelc)
Noble Member
Joined: 19 years ago

BTW, Where did you pick up your steel rod. $20 for all those pieces sounds like a great rate.


Reply
LightUpMA
Posts: 208
(@lightupma)
Estimable Member
Joined: 15 years ago

That's fantastic especially for your first time!!


Reply
Page 1 / 2
Share: