Help - Looking for ...
 
Notifications
Clear all

Help - Looking for PixClips

31 Posts
9 Users
0 Reactions
18.2 K Views
Posts: 47
Topic starter
(@whitebuck)
Trusted Member
Joined: 11 years ago

Sorry, I missed a bunch of posts, yes Doug showed you the prop and it is bar stock, so that was what I am looking to attach to. Once it arrives I can get measurements. I didn't think of 3D printing, but have to look into that.

Sent from my iPhone using Tapatalk


Reply
Posts: 2039
(@dougp)
Noble Member
Joined: 17 years ago

It is 1/4 thick by 1 inch wide bar stock.


Reply
Posts: 5
(@rainyoregonchristmas)
Active Member
Joined: 13 years ago

Hey guys, it's been a LONG time since I was on this site. With about a dozen pages sites to monitor, this one fell by the way side. Sorry about that. As far as the pixclips, yeah, the deal I had worked out fell through. As far as new production of clips, I'm working on that. It's quite a blow to loose out the way I did. I don't wish it on anyone.

As far as the Pixclip design, it does fit four different media. 1/4" x1/2" rectangular bar stock. 1/4" round stock, 550 paracord, and .025" x 3/8" poly banding strap. The pixclip 90 design fits 1/4" x1/2" rectangular bar stock exclusively.

If you would like to message me, please communicate with me in my "Rainy Oregon Christmas" facebook page. I check that most frequently.

Sorry the clips are in short supply, no one saw this closure coming.

-Matt


Reply
Posts: 944
(@didjareally)
Noble Member
Joined: 12 years ago

Just thought I would share, this was posted on the green site early this morning:

"I have found a solution, details in a few weeks. Looks like the clips may be back baby!!!"


Reply
Posts: 2048
(@scootchu)
Noble Member
Joined: 17 years ago
didjareally wrote:It could be something as simple as this, pixel clips into one side and the other side clips onto the wireframe, if you dont need the other portions of the clip then no reason to have them there, but it can always be added as well. Or if you prefer the pixel to face the viewer than I can adapt my pvc/bullet clip and it would have the pixel mounted facing the viewer.

Is that in Thingiverse?


Reply
Page 5 / 7
Share: