I have 5 RGB palm trees I need to make sure I am patching properly to the controllers. They are like a grid on the tree trunk.
My Hardware: Lynx Zeus controllers with a Pixelnet Etherdongle.
6 total strings with 126 nodes on each.
I have them broken down into 18 strings at 42 nodes each in the element setup.
One string will go up the tree 42 nodes, down the tree 42 nodes then back up the tree.
Everything looks and plays well in preview. How do I patch to the controllers and make it look right on the trees?
I was thinking I should patch element string 1 normal, element string 2 reverse then element string 3 normal and so on?
Thanks for any help.
I'm assuming you drew them with every other string backwards in preview. If that's the case, just patch it straight thru. No reversing should be necessary in patching.
--Jon Chuchla--
Sent from my iPhone using Tapatalk
I actually just used the mega tree tool in preview and made it look like it was wrapped around a pole.
then you can reverse the strands in the controller patching screen.
Martin
I tried checking the box to "reverse order of selected outputs" but it doesn't make a difference. If I manually do it pixel by pixel I can get it work but it is a lot more work. I'm wondering if accomplishing this in preview would be easier. Should checking that box reverse the order of the pixels? If it is supposed to it doesn't.
You can select multiple pixels and patch in one go rather than doing it one at a time. Simply expand the element and select from the bottom of the list upwards. I found it very quick to patch my strings this way.
I will give it a try. That would save some time. Strange way of working but I will take it if it works.
Thanks
damo1271, That worked perfectly and much faster. Thanks for the tip, I hope other can us it also.
Glad I could finally be a source of advice re vixen 3. 🙂
