Linking elements to...
 
Notifications
Clear all

Linking elements to controllers

5 Posts
3 Users
0 Reactions
2,117 Views
Posts: 13
Topic starter
(@rprade)
Eminent Member
Joined: 12 years ago
[#33865]

I don't know what happened. The first thread I started is in the forum, but is blank. I'll try again.

I have been able to learn how to get elements created, what I can't figure out is how to map these elements to controllers. I will be using SACN E1.31 so that I can use Ethernet to my controllers, likely multicast but possibly Unicast. I have 3 SanDevices E6804 controllers, some DMX controllers for dumb RGB strips, some DMX dimmer blocks and some DMX stage lighting. I completely understand how to map universes and channels on the SanDevices controllers as well as to create DMX outputs from the SanDevices controllers to individual DMX devices. What I can't figure out is how to map elements to these controllers. The page on "Link Elements to Controllers" is blank.

Can someone point me in the right direction. If I want to put a 3 channel RGB wall wash can on the front wall, and I have it programmed for channels 450-452 on Universe 4, how do I map an element to those channels and how do I set whether it will be output as Multicast or Unicast? If Unicast, I have to set the IP as well as the universe and channel.

I am a quick study, but brand new to lighting control software, controllers and protocols.


4 Replies
jchuchla
Posts: 8698
(@jchuchla)
Illustrious Member
Joined: 15 years ago

Your first thread should be back now. It was pending approval for some reason.

-- Jon Chuchla --

Sent from my iPad using Tapatalk


Reply
Posts: 419
(@txag2008)
Honorable Member
Joined: 17 years ago
rprade wrote:The page on "Link Elements to Controllers" is blank.

I'm seeing the same thing.


Reply
jchuchla
Posts: 8698
(@jchuchla)
Illustrious Member
Joined: 15 years ago

Well, that's an easy answer. It's because I hadn't written anything there yet, but I knew if I put up the empty page, people would remind me to do it. It's done now! Thanks for the reminder.:biggrin:


Reply
Posts: 419
(@txag2008)
Honorable Member
Joined: 17 years ago
jchuchla wrote:Well, that's an easy answer. It's because I hadn't written anything there yet, but I knew if I put up the empty page, people would remind me to do it. It's done now! Thanks for the reminder.:biggrin:

Nice. Thanks


Reply
Share: