Notifications
Clear all

DMX setup

20 Posts
4 Users
0 Reactions
7,970 Views
Posts: 77
Topic starter
(@larsande)
Estimable Member
Joined: 10 years ago
[#54403]

Strungling with controlling a fog machine (BeamX SI500) from a sequence. The machine is wired to my DMX port 3 on my falcon controller f16v3. And in my falcon player config I have added the port

Dmx 1

.
If I run the controller in testmode the machine is actived and sending out fog.
On my PI if I run a test on the specific channel 30608 the machine is also activated and produce fog.

Dmx 2JPG

In my sequence I try something like this:

Dmx 3

it do not work.

Dmx 4

Any ideas? - what happens on the test mode in Falcon player or testmode on the controller since they can activate the machine but the sequence can´t.


19 Replies
jchuchla
Posts: 8698
(@jchuchla)
Illustrious Member
Joined: 15 years ago

You don't need to patch a custom value thru a color breakdown. A custom value isn't a color, just a value. You should patch it directly to the output.


Reply
Posts: 77
Topic starter
(@larsande)
Estimable Member
Joined: 10 years ago

Great that worked.


Reply
Posts: 77
Topic starter
(@larsande)
Estimable Member
Joined: 10 years ago

So next issue is that I also have a DMX snow machine (Beamz SNOW1800). Trying to do a similar setup but it does not work. So running a test on Falcon Controller on Serial port 3 the snow machine runs.
But it do not start running doing a test run on PI and from vixen sequence either. Please have a look inclosed screenshots and hope you can guide me on the way.

Dmx 1

Dmx 2

Dmx 3

Dmx 4

Reply
Posts: 77
Topic starter
(@larsande)
Estimable Member
Joined: 10 years ago

Tried to do like this:

Dmx 5

Dmx 6

Did not work, any ideas what I could try?


Reply
Page 1 / 4
Share: