Connecting multiple...
 
Notifications
Clear all

Connecting multiple Renard Controllers

5 Posts
4 Users
0 Reactions
3,583 Views
Posts: 98
Topic starter
(@patmitchell)
Estimable Member
Joined: 8 years ago
[#51628]

Hello,
This is my first time using multiple controllers. Last year I ran out my usb into the converter that came with my Ren16 kit which transfers to a Cat5. I am assuming I am planning to run Cat 5 from my Ren16 into the Ren24 I now have. Is there anything special I need to put in Vixen to get it to communicate with the second controller or do I set it up so that it is identical to the Ren16 other than obviously the extra channels?


4 Replies
mikeh65
Posts: 794
(@mikeh65)
Prominent Member
Joined: 19 years ago

Set it up just like your Ren16 controller. Just add more channels. The first 16 channels will go to the Ren16 and the rest will be passed to the Ren24. Just be sure to start the Ren24 on channel 17. Even it you don't use all 16 channels of the Ren16 you need to account for them. Channels 1 to 16 will go the the 16 then channels 17 to 41 will go to the 24. If you add another, Ren24, then channels 42 to 66 go to it. The channels add up down the chain. Just be sure to put them in the right order.

Hope this helps


Reply
Posts: 98
Topic starter
(@patmitchell)
Estimable Member
Joined: 8 years ago

So I don't add it in as a separate controller I just create a single controller with 40 total channels?


Reply
MartinMueller2003
Posts: 7613
(@martinmueller2003)
Illustrious Member
Joined: 14 years ago

in vixen, all of the renard controllers in a single chain are configured as one big renard controller.


Reply
pmiller
Posts: 2795
(@pmiller)
Famed Member
Joined: 12 years ago

Keep in mind that you patch according to controller. So, let's say you have a 16 channel controller and an 8 channel controller. Your signal comes into the 16 channel and then out to the 8 channel. If you have only 14 items attached to the 16 channel then don't patch anything to channels 15 and 16. Leave them blank. Then continue patching to the 8 channel controller. Don't patch anything to unused outputs on the controller. If you do it will mess things up. Only patched used outputs.

Sent from my SM-T710 using Tapatalk


Reply
Share: