High sequence error...
 
Notifications
Clear all

High sequence errors

15 Posts
3 Users
1 Reactions
705 Views
Posts: 2456
(@jeffu231)
Famed Member
Joined: 15 years ago

Vixen sends all the time if the controllers are enabled even if nothing is playing. You can adjust some of that in the advanced tab in the controller universe tab by reducing the number of duplicated frames that are sent. This assumes your controller will manage that correctly. How many universes total are you running? Assuming a fair amount if matrixes are involved. What speed is the wired network? If you have over 200 universes on a 100M network, it could be getting saturated. What is the frame rate in Vixen set to? 50ms is the default for 20 FPS, and 25ms is 40 FPS. The higher the frame rate the more bandwidth it consumes, Is the show network shared with other general traffic in your home lan? Nothing has changed in the output logic in the sacn controller in Vixen in many years. DDP is more efficient if you are running into bandwidth issues if your controller supports it. Can you see what looks like skipping or lagging on the lights when it is playing to correlate to the errors you are seeing?

Some steps to try.

Validate you actually see problems on the lights to validate the errors are real.
Start turning off controllers in Vixen to see if the errors improve. If so, then that may suggest you have network latency.
Validate the update the frame rate. You can see it in the preview status bar.


Reply
Posts: 47
Topic starter
(@hilightsmt)
Trusted Member
Joined: 11 years ago
jeffu231 wrote:
Vixen sends all the time if the controllers are enabled even if nothing is playing. You can adjust some of that in the advanced tab in the controller universe tab by reducing the number of duplicated frames that are sent. This assumes your controller will manage that correctly. How many universes total are you running? Assuming a fair amount if matrixes are involved. What speed is the wired network? If you have over 200 universes on a 100M network, it could be getting saturated. What is the frame rate in Vixen set to? 50ms is the default for 20 FPS, and 25ms is 40 FPS. The higher the frame rate the more bandwidth it consumes, Is the show network shared with other general traffic in your home lan? Nothing has changed in the output logic in the sacn controller in Vixen in many years. DDP is more efficient if you are running into bandwidth issues if your controller supports it. Can you see what looks like skipping or lagging on the lights when it is playing to correlate to the errors you are seeing?

Some steps to try.

Validate you actually see problems on the lights to validate the errors are real.
Start turning off controllers in Vixen to see if the errors improve. If so, then that may suggest you have network latency.
Validate the update the frame rate. You can see it in the preview status bar.


Reply
Posts: 47
Topic starter
(@hilightsmt)
Trusted Member
Joined: 11 years ago

I’m only running 88 universes. I can’t find the frame rate in Vixen. It’s a 100m. It happens when with only one controller running. I did find I had the last universe on one affected controller set at 510 instead of only the 382 it needed. It did stop the errors for that universe. The pixels run perfectly, I don’t see a skips or lagging. Thanks for your help.


Reply
Posts: 47
Topic starter
(@hilightsmt)
Trusted Member
Joined: 11 years ago

I unpatched the controller and deleted it. I added it again and repatched everything and now I’m on getting a large amount of errors on the higher universes. Before it was progressively higher as the universes went up. The pixels seem to run fine. I’m so confused on this.


Reply
MartinMueller2003
Posts: 7612
(@martinmueller2003)
Illustrious Member
Joined: 14 years ago

You are sending the controller more data than it can handle.


Reply
Page 2 / 3
Share: