I’m running 7 Sandevices E682’s with Vixen. I’ve noticed I’m getting a a massive amount of sequence errors on some controllers. The errors get progressively higher as the universes increase. I’ve noticed it’s more on the controllers running matrices. All the pixels run fine. All the universes and patches are ok. I was wondering if anyone has experienced this? Is it something in Vixen lights? Any insight would be appreciated. Thanks. Lights on Pine St.
This typically indicates the controller is overwhelmed.
Are you running multicast? If so the packet order is not guaranteed and if they come out of order, or never arrive, that can cause sequence errors. This more likely on wifi, but it can also happen on wired connections. Network saturation and other network quality issues can also cause it, but multicast is the most common that I have seen.
jeffu231 wrote:
Are you running multicast? If so the packet order is not guaranteed and if they come out of order, or never arrive, that can cause sequence errors. This more likely on wifi, but it can also happen on wired connections. Network saturation and other network quality issues can also cause it, but multicast is the most common that I have seen.
No. All the boards are running in unicast. One board has new firmware but it’s not that because the other board is still running the old firmware. The 3 boards that do it are running matrices. It gets worse as the universes increase. They are getting massive amounts of errors. I do have a new computer and I am running the most current version of Vixen. That’s the only two things that have changed. Any suggestions would be appreciated.
hilightsmt wrote:
No. All the boards are running in unicast. One board has new firmware but it’s not that because the other board is still running the old firmware. The 3 boards that do it are running matrices. It gets worse as the universes increase. They are getting massive amounts of errors. I do have a new computer and I am running the most current version of Vixen. That’s the only two things that have changed. Any suggestions would be appreciated.
Also I forgot to mention it also happens when vixen is sitting idle. I’m hardwired thru a network switch. It also happens when I plug one of the boards directly into the computer.
