I'm doing some testing with an Arduino Mega to control both pixels and solid state relays from Vixen 3. I have a spiral tree with star topper using 100 WS2811 pixels that occupy the first 300 generic serial channels (works fine). I created an additional 32 element RGB group and added 96 channels to the controller count. These elements will be used to control the relays from the same CRGB array that the WS2811 pixels are controlled from. When I attempted to patch the 32 elements to the 96 channels, only 32 channels were patched. The 32 elements are configured with a color filter for RGB any color so I need 3 channel patching per element. Any ideas why I can't patch to all 96 channels???
Did you select enough channels on the output controller when you were patching?
--Jon Chuchla--
Sent from my iPhone using Tapatalk
Yes (verified by my own math and the channel count indication in Vixen). I tried lots of combinations of closing the program, re-creating the controller, etc. without success. In the end, I figured it wasn't a controller issue but a color filtering issue. I spent quite a bit more time fooling around with this because the filtering is pretty "touchy" to me. My pixel tree and pixel star were filtered for RGB any color as you would expect, but when I added the 32-element group, I couldn't get it to accept RGB any color (which is why it wouldn't patch additional channels to the controller beyond 32). Yesterday, I tried it again and was able to assign the 32 elements as RGB any color. After confirming that, the patching worked as expected on the controller side. I don't know why I had such a hard time with assignment. I do get confused on the filtering side of the window because their are two Settings buttons: one for the Dimming Curve/Color Handling selection and one just below for after a color filter has been selected. Each Setting button brings up the same sub-window.
Sounds like you got it. You probably had something residual in there from the multiple attempts.
The configure drop down box is to invoke "wizards" to set up either color handling or dimming curves. When you use the color handling wizard it will do two things. It will create the color property for each element. And it will create and configure the color filter connected to each element. That box under the configure drop down is the property list. The color property tells an element what colors it can be and whether or not they mix. This affects the color selections you get when putting effects on the elements in the sequencer. The color breakdown filter is seen only in the graphical view of display setup. You can edit it by double clicking. This is what takes the full color values of the element and separates it into multiple control channels to be routed to controllers. It also has an option for whether or not the colors mix so it can sort it out properly.
So while the property and filter are related, they're two different things. The wizard helps you set them both up at once. But after they're created they have to be edited or deleted separately.
Outside of color, There are properties that aren't related to filters such as location and position. There's also filters not related to properties such as dimming curves. These only appear in the graphical view and have no corresponding entry in the property list.
--Jon Chuchla--
Sent from my iPhone using Tapatalk
Thanks for the timely and detailed clarification, Jon! On a slightly different note, from a Vixen standpoint, is there any reason I couldn't run both my Arduino via Generic Serial controller and an E.131 controller for Ethernet output to a SanDevices card simultaneously. With the appropriate patching in place, I'm assuming Vixen would simply send the applicable data stream to each destination. I ask because I'm thinking of using the Arduino for dedicated SSR switching of single color LED strings while the SanDevices controller is doing its thing with RGB pixels.
