Notifications
Clear all

Flickering

13 Posts
4 Users
0 Reactions
5,496 Views
Posts: 25
Topic starter
(@ryanb)
Eminent Member
Joined: 7 years ago
kev wrote:Yes, that is what I was referring to. Vixen starts to output as soon as it is launched albeit all zero's. So I was thinking that you were getting un-synchronized data.
When you close Vixen, the random lights feature of VictorPV sketch is supposed to kick in.
Is the Arduino powered up before launching Vixen? Vixen may not assign the correct USB port if not.

Every time so far the Vixen is plugged into my computer through the USB and on before I launch Vixen.


Reply
Posts: 25
Topic starter
(@ryanb)
Eminent Member
Joined: 7 years ago
Display

Graphical

Config

Arduino properties

Reply
Posts: 1592
(@ruppro)
Noble Member
Joined: 11 years ago

You have the Com port Baud rate in Vixen as 57600 but on the Arduino you have it set to 9600, shouldn't they match?


Reply
Posts: 25
Topic starter
(@ryanb)
Eminent Member
Joined: 7 years ago
Ruppro wrote:You have the Com port Baud rate in Vixen as 57600 but on the Arduino you have it set to 9600, shouldn't they match?

I had it set to 57600 last night it didn't affect anything positively so I just put it back to that as a default.


Reply
Posts: 1387
 kev
(@kev)
Noble Member
Joined: 12 years ago

Do you see any of the LEDs on the MEGA flashing as if receiving data? Do you have a picture of your setup?


Reply
Page 2 / 3
Share: