Notifications
Clear all

Flickering

13 Posts
4 Users
0 Reactions
5,495 Views
Posts: 25
Topic starter
(@ryanb)
Eminent Member
Joined: 7 years ago
[#53340]

So I ran a display without hiccup last year, 16 channels all on SSR's. This year I go to set everything up and once I open up Vixen even though no sequences are being run the lights begin to flicker/blink rapidly. Has anyone run into this issue and come up with a solution? I am currently using Victor's code for the Arduino and I'm certain I have the right baud rate and COM ports selected.

Cheers in advance,
Ryan


12 Replies
Posts: 25
Topic starter
(@ryanb)
Eminent Member
Joined: 7 years ago
RyanB wrote:So I ran a display without hiccup last year, 16 channels all on SSR's. This year I go to set everything up and once I open up Vixen even though no sequences are being run the lights begin to flicker/blink rapidly. Has anyone run into this issue and come up with a solution? I am currently using Victor's code for the Arduino and I'm certain I have the right baud rate and COM ports selected.

Cheers in advance,
Ryan

So I reuploaded the code to the arduino and that seems to have solved the flickering which is awesome. However now when I initially open it still flashes once, which may be normal, and when I attempt to run a sequence nothing happens. Also when I close vixen it just repeatedly flashes but only once and every few seconds.


Reply
Posts: 1387
 kev
(@kev)
Noble Member
Joined: 12 years ago

Do you have the header characters entered into the Generic Serial controller configuration?


Reply
Posts: 25
Topic starter
(@ryanb)
Eminent Member
Joined: 7 years ago
kev wrote:Do you have the header characters entered into the Generic Serial controller configuration?

Are you referring to the tilde and exclamation point(~!) ? If so yes.


Reply
Posts: 1387
 kev
(@kev)
Noble Member
Joined: 12 years ago

Yes, that is what I was referring to. Vixen starts to output as soon as it is launched albeit all zero's. So I was thinking that you were getting un-synchronized data.
When you close Vixen, the random lights feature of VictorPV sketch is supposed to kick in.
Is the Arduino powered up before launching Vixen? Vixen may not assign the correct USB port if not.


Reply
Page 1 / 3
Share: