I have three leaper loops and when I watch the preview they are super fast. How does everyone normally program leapers? do you use a fade? I'm using 50ms and 5 sets of lights per leaper. Should they just flash 1, 2, 3, 4, 5 or should I be doing something else?
Thanks!
TazViper10 wrote:I have three leaper loops and when I watch the preview they are super fast. How does everyone normally program leapers? do you use a fade? I'm using 50ms and 5 sets of lights per leaper. Should they just flash 1, 2, 3, 4, 5 or should I be doing something else?
Leaping arches are sequenced just like any other chase sequence. It depends a lot on the speed of the music you want to sync to, and your preferences for how you want it to look. For example, if the beats were at .25 sec intervals and you wanted one leap per beat, then you would have 5 intervals per leap so you would need to turn on another arch segment for each interval (red in the example), but if you only wanted them to leap "half speed", then you could wait 2 intervals between turning on each additional arch segment (blue in the example). OTOH, if you want a "comet" appearance, you might use a longer fade even on a faster leap. In extreme cases (very fast music), you might even need to turn on more than one segment per interval in order to get a complete leap per beat (if that is your goal).
You might also need to vary the number of segments that turn on per interval in order to sync with the beats, but if the arch is leaping fast enough that will not be noticeable to the viewer.
How many intervals each segment stays on and whether they fade or aburptly turn off will affect the illusion of speed. Slower leaps may look better with longer "tails" (longer time on per segment and/or longer fade), while faster leaps may look better with shorter tails (to reinforce the illusion that it is moving faster).
Since it is very subjective, set up a test sequence to run one way for a few seconds, then lengthen or shorten the tails or intervals between and run a few more seconds, then maybe try another variation. Then play the whole test sequence in a loop over and over and try to pick out which variation looks best for the music you are syncing to.
don
Everything Don said...plus
I use all the techniques he mentioned but want to emphasis making sure the leap starts and finishes (other end of arch) on a down beat with the song. If countinuing on the the next arch the same down beat of the end of the first arch is the start of the second arch. This makes a huge difference in the end-effect. Try it this way and without regard to the beat and you will agree I bet.
Thanks! This helps a lot!
