Notifications
Clear all

X10 Plugin?

8 Posts
4 Users
0 Reactions
3,933 Views
Posts: 196
Topic starter
(@michael)
Reputable Member
Joined: 19 years ago
alwysrit2 wrote:Micahel, If you have the firecracker or a computer interface to it, you should be able to create a .bat file, then setup a Vixen Sequence with the Launcher plug in to run the .bat file with different parameters.

I know there are other threads talking about a true X10 plug in, but I have never seen any results from them.
Good luck!
-Don

That is the answer I was looking for.
I do have several of these interfaces, but did not know they had a command line interface, or that Vixen could launch them like that. I will have to dig out the docs on them and play a little.
Thank you !

- Michael


Reply
Posts: 150
(@alwysrit2)
Estimable Member
Joined: 19 years ago

Here is the command from my .bat that I have used with my ActiveHome Pro (USB).
c:\Halloween\ahcmd.exe "sendplc" "%1 %2 %3"

I think this is what I used for the Firecracker -
C:\Halloween\Mscm17a.exe -p 1 -c

I believe both of these use the same paramters - House Letter, Device Number, Action
Action = On, Off, x%, etc


Reply
Posts: 93
(@deast)
Estimable Member
Joined: 19 years ago

I have the firecracker and the serial/standalone interface. With the second one, It can receive signals from my motion sensors. I had it wired up at one point to turn on a light when I walked into the basement. I forget the software I was using.


Reply
Page 2 / 2
Share: