Notifications
Clear all

TCP/IP Control

4 Posts
2 Users
0 Reactions
3,382 Views
Posts: 8
 Jimm
Topic starter
(@jimm)
Active Member
Joined: 17 years ago
[#9851]

Has anyone made a plug-in for an AMX, Crestron or Medialon control system? I would like to control Vixen with a control system that uses TCP/IP. A few things I would like to do is get triggers from traffic or IR sensors, get triggers from standard buttons that guests would push or control relays for groups of lights. I have all of the hardware to make this work I just need the plug-in.
On a related but slightly different subject: has anyone put relays on the commons of the output of a DMX controller so that that controller can be used for multiple lights that do not have to be on at the same time?
I looked around a bit and could not find much on the subject. If the topic already exists please point me in the right direction.
Thanks,
Jim


3 Replies
budude
Posts: 10400
(@budude)
Illustrious Member
Joined: 18 years ago

Hey Jim - first of all Welcome to DIYC!

Not 100% sure if this is the direction you want to go but there is Art-Net support for Vixen to do DMX over IP - you can look through this thread for details.

There is also support in Vixen for inputs using a variety of methods like joysticks (which are really just switches anyway), Midi, etc. Search through the forums as there are quite a few. If you don't see what you need then ask again with something specific for what you want to do.

Again - Welcome!
Brian


Reply
Posts: 8
 Jimm
Topic starter
(@jimm)
Active Member
Joined: 17 years ago

Thanks for your response Brian.
Here is a little more info on the matter.
So I am ok in the DMX world, Vixen to DMX controllers is all good and works. For next year I would like to add I/O control. A control system like AMX would handle all of the I/O devices like buttons and or relays. What I still need to sort out is the communication between the control system and Vixen. I would like to be able to send TCP/IP commands from the control system to Vixen that would start a sequence. Feedback from Vixen back the the control system would be nice but not necessary. The control system will tell Vixen when to start a sequence based on a button press or a trigger from a car driving over one of the two sensors. The control system will also trigger relays based on the time that it started the Vixen sequence.
Jim


Reply
budude
Posts: 10400
(@budude)
Illustrious Member
Joined: 18 years ago

There are network triggers in Vixen as well - - I personally don't know much about it but again a search through the forum might get you there. Note that plug-in development is open for Vixen if you are so inclined/able to do so.


Reply
Share: