Parallax PSC Plug-i...
 
Notifications
Clear all

Parallax PSC Plug-in

2 Posts
1 Users
0 Reactions
2,390 Views
Elmo2resc
Posts: 265
Topic starter
(@elmo2resc)
Reputable Member
Joined: 19 years ago
[#3815]

I can't get the parallax PSC plug-in to work with a parallax servo controller (serial). I get the error code "could not determine baud rate for the PSC unit"

http://www.parallax.com/Store/Microc...%2cProductName

I supply it 5 volts via a pc power supply
+ to + and - to -

Pin 3 was hooked up to the serial in on the board
Pin 5 to ground on the board

pc was set to "baud 2400" "Stop bits @ 2" "Com port 1"

Vixen was set to match this

I supplied power for the servos also through 5 volts of a pc power supply.

I heard there were still some bugs with this plug-in. any ideas?
The leds light up on the board but that is it. I tried different variations of set-up and still no luck. Thanks for any help with this. Jerome


1 Reply
Elmo2resc
Posts: 265
Topic starter
(@elmo2resc)
Reputable Member
Joined: 19 years ago

Looks like I need to add this to the equation. I hope I didn't ruin it.
Jerome

http://forums.parallax.com/forums/attach.aspx?a=12825

RS-232 (PC) to Parallax, Inc. Servo Controller (PSC)

Our Parallax Servo Controller (#28023) is typically controlled by one of our microcontrollers. For PC control we have a USB version (#28823). For those who have the Serial version and wish to connect to the RS-232 Serial Port you can use the following schematic. It consists of only 5 discrete components which are readily available from Parallax, Inc., Radio Shack or any electronics store or distributor. With this schematic you have full control and can even use the PSCI software intended for the USB-PSC. Please note that a regulated 5V power supply is required for the circuit which also powers the PSC. This supply must be separate from the power supply for the servos, which connects to the screw terminals on the PSC. Take care.

NOTE: Any data sent to the PSC by the host will be echoed back through the RS-232 connection. This is a side-effect of using a single I/O pin for bi-directional serial communication. Be sure your host application disregards anything sent to the PSC. Essentially you will need to filter what you send from the receive buffer.

PC to PSC.bmp

Component Description Source Part #
--------- --------------- --------- ------------
R1, R2 1K, 1/4W, 5% Parallax, Inc. 150-01020
R3 10K, 1/4W, 5% Parallax, Inc. 150-01030
Q1 NPN, 2N3904, TO-92 Parallax, Inc. 500-00001
Q2 PNP, 2N3906, TO-92 Parallax, Inc. 500-00003

--------------------------------------------------------------------------------


Reply
Share: