jwilliams31 wrote:I did not know this. Ok, I set the crossfade to 0 and it seems to be working OK now.Is there a way that I can make sure there is a few seconds of "quiet time" in between sequences in the program? There are a few extra seconds at the end of each sequence, but I just didn't want it to roll from one song right into the next. I thought a dramatic pause would be nice.
Thanks.
Jason
The cleanest way IMHO is to use audacity to add some quiet time to the end of each song, but since your sequences are done, I doubt you would would want to do this. There's no reason you can't make a sequence that is say 10-15 seconds long, and have it either be empty or have static lights and insert that multiple times in your program, like between each song.
Cbell's idea works well for that. I do not have any gap in between songs, but I had to create one at the top of my program to solve the com port access error (thanks Rokkett for this grand idea!!). I just use a 5 second program that is NOT associated to my profile, and has only the adjustable preview plugin configured (basically not configured, don't even have a picture in it). But it will add 5 seconds of blank between the songs very seemlessly.
-James
Well I have determined that running the Triks is causing my program to crash. I ran it last night without the Triks and no problems. What could be causing this and how do I fix it?
Any imput would be appreciated.
Thanks,
Mike
kiowamike wrote:Well I have determined that running the Triks is causing my program to crash.
Sounds like you're running a vanilla LEDTriks board -- no Triks-C, right?
As was previously suggested, you might have a bad parallel port on your PC. Can you run the LEDTriks sequence alone, without lights, for any considerable amount of time without the machine crashing?
Another issue is that the PC may be under-configured for what you're trying to accomplish -- the overhead of processing the LEDTriks data is pretty substantial and you may just be asking the computer to do more than it can handle.
If you have access to a second PC, you might consider running the LEDTriks off of one machine and run your lights controller off another. The second PC could also help you determine whether the parallel port is screwy (that's a technical term).
HTH; BOL.
\dmc
I'll give all that a try. The only thing is I do not have access to a second computer with a parallel port (one desk top and one laptop). Should I create a program for the Triks or just loop the sequence for a while? Correct on the vanilla Triks. I do have a Triks-c board, however I haven't figured out how to intergrate it into Vixen.
Well it appears that I can run a Triks sequence by itself almost indefinitely. I had a test sequence looping for over two hours before I stopped it so the show could start. I might try to run it in a scheduled program to see if that changes anything. Before I turned the Triks off for the show, it would run for about 15 to 20 min before it would crash.
kiowamike wrote:I do have a Triks-c board, however I haven't figured out how to intergrate it into Vixen.
You don't 😉 ...
The Triks-C is driven by a separate application -- you use Vixen to create the sequence (it's a .led file) and then a command-line application called LTC actually executes the sequence.
I have LTC set up to launch on its own (via batch files and "Scheduled Tasks") and it runs completely separate from Vixen.
If I were you, I'd spend some time trying to get Triks-C and LTC to work.
Best o' luck.
\dmc
That is my plan for this weekend. I just didn't have enough time to play with it before I had to start setting up.
