Ok got a weird one here. I have writtien all my sequecs on a laptop which has comm prot 3. I can schedule a program and it will run no problem. Now my show pc is comm port 1. So i have only copied the sequences over and not the profile to cause a confilct. I am able to run a sequence in the editor just fine no errors but cannont get a program to run schedule. I have followed the wiki and even changed the profile but still nothing. What is causing it not to allow the show to play. Please help, i have spent so much time fixing issuse with ssr's and blowing or triping breakers and now i cant even play the show. Also tried to download a different version of vixen and cant due to bandwidth issues on hosts end.
Chris
Did you change the com port in the plugin to reflect comm port 1?
Rick
Yes everything is set to comm1 only thing i copied were sequences and i made sure the profile was right as well as each individual sequence. I am able to preview the show in the show on the program manage screen...(where you would setup show) so i can play it at that point but need it to start on its own and turn off.
I downloaded 2.1 to try and cant get it to work either. Am i missing something on my pc that wont trigger the scheduler? I can get it to work on my laptop but it has not serial output.
Chris
😀 i did the same thing that you are doing. When i went to add the program to my desktop, I had to make sure the settings were set on the pc. Going into set up making sure your channels are set. And the correct baud rate and port. Hope this helps
Copy your old PROFILE from the other computer to the profile folder. Then use notepad to open it. Scroll down, near the bottom you'll see a tag named like the following. Change the parameter to be the right port for you. If it was COM3, change the 3 to a 1. Then save it.
COM1
57600
None
8
One
1
True
The problem is likely that the profile doesn't match the sequence data. Profiles and sequences are matched pairs and it's not a great idea to copy one without the other...
The above should work.
I am having a similar problem, well not exactly. When I modified Franks(Fkostyun) routines that he posted on his web site, The lpt1 outputs remain (low) all thechannels turned on before and after the sequence is finished. During any of these sequencies the channels that are turned off are lit and the blinky flashy channels thatare supposed to flash do flash. its like the parallel port's outputs have been inverted. When I use one of my old routines everything is ok. Something in the new routines is causing the lpt1 data to be turned on. I h9ope I explained my self properly. Bottom line I cant turn off the lights all channels (simple 595 128 channels no dimming are on!)
Rice66
Is your parallel port in EPP mode or has a Windows update shifted it? Sometimes when I have a port problem, I'll actually go into the Windows hardware device manager, delete the port, shut down Windows, and actually power the computer off for about 15 seconds to let all the internal electronics equalize.
Then power it back on, check the CMOS settings and change if necessary, and let Windows fire up. It'll rerecognize the ports and realign them in the registry. After that, check the port properties to make sure they're working properly, check Vixen's address settings (if necssary) and try it again.
I co-own a software company that produces custom accounting, POS and credit card software and winter static electricity often raises havoc with common external POS devices (pin pads, printers, card swipers, etc.) and this practice usually fixes those problems for us. Might work in this case, too.
I hope so, I am araid I might have fried the ltp1, but hey I will try anything at this point. I even have a card that has two parallel outputs on it, I bought it sometime back and I have tested the board, although it is in another computer at the moment. Thanks for the information.
Rice66

