I know there is a way to see how much power your using in a sequence in vixen however, I can not figure out how to do it. From what im told you can watch what the power is doing in each section of the sequence?
Thanks in advance! 😀
You want to use the Watt Meter Add-In. You'll need to put in the maximum amps/watts of each channel and then it will calculate how much is used for the complete sequence. Of course it's only an approximation and only as good as the numbers you enter but it can get you in the ball park.
It’s called ‘Watt meter’ in the ‘Add-ins’ tab. You have to enter the on current for each channel, and then press the ‘Calculate’ button. It will graph out your entire sequence by time.
It’s pretty cool. I use it a couple of years back to operate 40 amps worth of lights through a single 15 amp outlet. It worked great, never popped the breaker and the sequences still looked fine.
Double post..
I hate to waste this space so it's for sale.:D
Thanks! This will def help out since I am after all using Mini lights and not LEDS. I hope to b able to get about 50,000 lights without throwing my electric bill through the roof. im figuring another 200 bucks on top of what is already paid.
I did not use the power meter add in (pretty cool by the way). I manually calculated the load, but I did not see a significant difference in my electric bill last year.
Animation makes a huge difference in the electricity cost. Most of the time, mine showed 10% or less of total current. Hardly ever is everything on at the same time. Though you don’t see it in real time, I turn off or dimmed down something while something else turned on or dimmed up.
With 40,000 lights, the best we could determine (with an estimated bill) we only increased by $10 or so.
ErnieHorning wrote:Animation makes a huge difference in the electricity cost. Most of the time, mine showed 10% or less of total current. Hardly ever is everything on at the same time. Though you don’t see it in real time, I turn off or dimmed down something while something else turned on or dimmed up.With 40,000 lights, the best we could determine (with an estimated bill) we only increased by $10 or so.
I wish mine only went up 10 bux. I only used about 18000 minis last year, set all channels to a maximum brightness of 75% or 80% and did like you when something was ramping something else was fading and mine increased about 75 bux. And I didn't have to use the heater consistently until about January or Feb.
mkess wrote:And I didn't have to use the heater consistently until about January or Feb.
What did you use a heater on?:confused:
