I'm just getting started with computerized Christmas lights and Vixen and I made a 12 LED test board to connect to the Parallel port via the DB25 connector. It works perfect on the on-board LPT1 using the 12-channel Parallel plugin, I can turn on/off each LED using the Test Channels panel. I just installed 2 additional PCI based Parallel ports made by Manhattan and they don't work. I have tried many things like looking at the device Manager to get the Memory Address and enter that as "Other" and restarted but it still didn't work.
The Device Manager shows my LPT2 as "PCI EPC Parallel Port (LPT2)" The I/0 Range is E480 - E487 and under that it's E400 - E407. So just guessing I tried using E480 in the Other box in the Plug-In and also Tried E400, restarted both times and still no control over this port. Any ideas on this please let me know as I no clue what to try next... Thanks
harpster wrote:
...
The Device Manager shows my LPT2 as "PCI EPC Parallel Port (LPT2)" The I/0 Range is E480 - E487 and under that it's E400 - E407. So just guessing I tried using E480 in the Other box in the Plug-In and also Tried E400, restarted both times and still no control over this port. Any ideas on this please let me know as I no clue what to try next... Thanks
I think you need to get the card into EPP mode rather than EPC if that is possible. Good luck!!
.
I don't think that's it but maybe. The device manager shows the motherboard port that works ads "LPT1 as ECP Printer Port" and the card I installed with 2 additional parallel ports says it's EPP, ECP, and SPP compatible. But it also says it's for use with Legacy Devices whatever that means? Maybe Vixen is not compatible with that???
Clarification: My Parallel Port PCI Card says: "Compatible with ISA Parallel Port Addresses For use with Legacy Devices".
That should mean it will appear to be just like a motherboard parallel port and show up correctly in the device Manager as LPT2, and LPT3 which it does... so it should work with Vixen but the I/O address is not 0278 or 03bc. When I choose Other and put in the I/O address shown in the device Manager it doesn't work. Aren't PC's great!
harpster wrote:I'm just getting started with computerized Christmas lights and Vixen and I made a 12 LED test board to connect to the Parallel port via the DB25 connector. It works perfect on the on-board LPT1 using the 12-channel Parallel plugin, I can turn on/off each LED using the Test Channels panel. I just installed 2 additional PCI based Parallel ports made by Manhattan and they don't work. I have tried many things like looking at the device Manager to get the Memory Address and enter that as "Other" and restarted but it still didn't work.The Device Manager shows my LPT2 as "PCI EPC Parallel Port (LPT2)" The I/0 Range is E480 - E487 and under that it's E400 - E407. So just guessing I tried using E480 in the Other box in the Plug-In and also Tried E400, restarted both times and still no control over this port. Any ideas on this please let me know as I no clue what to try next... Thanks
I've had problems with ports configures as anything but "output only." I've had to go into device manager and remove the port, configure it in BIOS as output only then restart windows and allow it to re-install the port. Seems like anything other than output only and windows keeps all the lines high for reading device status.
I hope this helps.
Merry Christmas...
Steve Rose
