hi all,
i am wondering if there is a way to change the intensity in a whole sequence at one time or if i have to do each block separately. i am using someone else's sequence. it has fades in it and i do not have that capability yet.
thanks for all the help
You can select any range of cells (the whole sequence if you want) and then right-click and select "Set intensity" (also found in the "Effects" menu).
the easiest way to adjust the entire sequence level is to (with the sequence open) click sequence on the top left. then select settings. It gives you a range of 0-255. if you want 90% just multiply .90 x 255 to get the exact level. Whenever you do sequence adjustments like this i first like to save the entire sequence at 100% in a 100% folder and use the copy to make adjustments. Hope that helps!
When i try both (set intensity or settings) it changes the entire sequence to full on or off. i want only the lower intensity blocks to go to full intensity.
thanks
If you want only certain cells to be on full , then regretfully , your gonna have to click on them , and change them that way . 🙁
I think this has been discussed in another thread - but one way that I think should work is to use a dimming curve (you have to use Vixen 2.5 to have this). Set the curve so that at some point - say 128 and above, it changes the lights to 100% and anything below it changes the lights to 0%. You then apply that curve to whichever channel(s) you want. This has an advantage that it does not change the sequence itself - only the final output. You can play with multiple curves to get the right turn on/off point for each sequence.
I think this is what you want...
Highlight all the cells you want to raise/lower. Press .
I'm not sitting infront of Vixen or I would try this. Have you tried to create a block of 100% on cells and then boolean paste ('AND' maybe or there are some others) over the top of a whole block (both 0 and with some fade) and just have the ones that were on at all go to 100% ?
buldog198 wrote:i want only the lower intensity blocks to go to full intensity.
If you are using Vixen 2.1 (pre-dimming curve), and it is one specific value that you want to change to full, select all the cells where that value might be (ie, by dragging the mouse over the whole sequence or part of it), then use the Edit -> Find and Replace menu item to change the old value to the new value (beware that some functio ns use 0 - 100 % values whereas other functions use the absolute brightness value 0 - 255).
If it is a range of lower values that you want to change, first set the minimum intensity (as described previously), which will pull up all those values to the minimum value, then use the Find and Replace as described above.
don
thanks the find and replace worked the best
i did not see it earlier.
